Repair your vehicle right away. Just click on the link I attach-
2001 Mazda Tribute Workshop Repair Service Manual PDF Download
SOURCE: 2001 tiburon has no spark. replaced coil pack and
You have crank sensor problem . No signal to computer if no signal to computer no ejector pause
SOURCE: Where is the ignition coil pack located on 2002
The ignition power pack and (aka ignition coil) is located on the 2004 Mazda MPV at the end of each spark plug wire on top of the spark plug. The front ones are easy to replace and all 3 can be done in about 30 min. The back ones are another issue. I had to take off the intake manifold on the top of the engine to get to them. This was about a 5 hour job. The installation of the new unit is pretty simple once you gain access to them. you simply disconnect a clip on wire and take out one screw and reverse the process to put in the new ones. Factory units run about $80 each. You can get them at other locations in after markets for as low as $55. Good Luck.
SOURCE: car stereo wiring diagram for 2001 mazda tribute
Car Radio Battery Constant 12v+ Wire: Orange/Light Green
Car Radio Accessory Switched 12v+ Wire: Yellow/Black
Car Radio Ground Wire: Black
Car Radio Illumination Wire: Light Blue/Red
Car Stereo Dimmer Wire: N/A
Car Stereo Antenna Trigger Wire: N/A
Car Stereo Amp Trigger Wire: Light Blue
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Orange/Light Green
Left Front Speaker Negative Wire (-): Light Blue/White
Right Front Speaker Positive Wire (+): White/Light Green
Right Front Speaker Negative Wire (-): Green/Orange
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Gray/Blue
Left Rear Speaker Negative Wire (-): Brown/Yellow
Right Rear Speaker Positive Wire (+): Black/Violet
Right Rear Speaker Negative Wire (-): Orange/Violet
SOURCE: 2001 Mazda Tribute (3.0 L) Heater motor functions on high only
Its the Blower Resistor....If it was the switch, it probably wouldn't work at all....But the Resistor will give you those symptoms, of working on high med or low
SOURCE: 2001 vw jetta vr6 need the firing order and
For the 2.8L DOHC V-6:
Firing Order:
1-5-3-6-2-4
Cylinders:
......(back).......
|.1....3....5....|
|....2....4....6.|
Ignition Coil Connections
(back)
|.2..5.|
|.4..3.|
|.6..1.|
(front)
Let me know if this helped, or if you have additional information of questions. Feel Free to contact me at FixYa.com!
904 views
Usually answered in minutes!
×