SOURCE: 1997 buick le sabre
its the electrical connection at he fuel pump,if this is ok ask if they replaced the strainer on your fuel pump,your fuel pump is inside your gas tank ,you have to drop the tank to service,most fuel pumps are not warrantied if you dont change the strainer,when your car shuts off the sediment on the strainer falls back into the tank,but when you run your car and it sucks up the gas thru the strainer to the pump it clogs the strainer and the fuel pump cant pump,you shoiuld find out if they changed this because your forcing your fuel pump to work harder,was it a new fuel tank or used one that they put in
SOURCE: 1988 buick la sabre trouble codes
code 23 is mat sensor signal low wich is the manifold temperatur sensor return valtage is low to the computer. check for a sensor that is on the air cleaner housing that has two wires on it. the connector on the sensor is grey in color. if it's not unplugged replace it.
the code 34 is for the map sensor wich is located on top of the engine. but if you have a bad map sensor you would be writing in for a rough running car or something.
was someone unplugging stuf when this thing was running at one time? - good luck
SOURCE: how do I replace the water pump on a 1994 buick la sabre
3.8 engine you drain out coolant.remove serpentine belt and coolant hoses from water pump .then you remove pulley bolts then water pump bolts. then clean gasket surface be careful dont scratch the surfaces up.put in new pump. toque it to 29 ft the long bolts.torque .97 inch pound for short bolts.
SOURCE: need to replace fuel pump on 97 buick la sabre
it's in the fuel tank! need to get it u in the air about 4 or more feet of the ground. you may get away with it being less and there is two straps holding the tank it they are attached to the body with 15mm bolts. you will need to disconnect the filler neck where you put gas by taking the hose clamps off and then disconnect fuel lines and electrical after you have it half way down straps removed! ask any more question you have
SOURCE: how do I replace my fuel level sensor on a 2000
Access via trunk, remove carpet and find inspection cover, remove to access fuel level sending unit which is attached to the fuel pump.
71 views
Usually answered in minutes!
×