Cars & Trucks Logo

Related Topics:

R
Ronald McClellan Posted on Mar 13, 2017

My 2008 Hyundai Accent GLS has a problem with its ignition switch . if you take the key out of the ignition then push it back into the switch the switch is locked and will not turn to start the car .

5 Related Answers

Anonymous

  • 2920 Answers
  • Posted on Aug 22, 2008

SOURCE: hyundai accent 1996 steering lock removal

try tunring the key and the whell at the same time it should release the lock.

Ad

Anonymous

  • 710 Answers
  • Posted on Apr 22, 2009

SOURCE: My hyundai accent 1.3 does not start when you turn

check battery voltage and alternator output. Most auto parts stores will check this for you at no charge

Anonymous

  • 2050 Answers
  • Posted on Oct 01, 2009

SOURCE: hello i have a 2008 hyundai accent gls. it has

Get it scanned. You should be under warrantee. Otherwise most auto parts stores will do this. Could be as simple as a loose gas cap.

A

Anonymous

  • Posted on Apr 28, 2010

SOURCE: need obd reader for hyundai accent gls 1999

Sure you can. Put a scanner on the diagnostic connector under the dash and check for codes. The codes you get ,do not tell you what is wrong or what to fix,but a starting point for the diagnostic steps you need to take, to find and repair the issues your having. Now --you need an understanding of your vehicles systems and possibly a wiring diagram, to reach a successful conclussion. That's where a professional shop comes in.

Anonymous

  • 4793 Answers
  • Posted on Jul 02, 2010

SOURCE: I want 2002 Hyundai Accent GLS Repair, Maintenance,Service Manual

buy a Haynes manual......

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How to replace ignition switch on a hyundai tiburon

Removal & Installation

Specific to:
Hyundai Entourage 2007-2008
  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Disconnect the negative (-) battery terminal.
  3. Remove the crash pad lower panel (A).

    0996b43f80e41e86.jpg
    enlarge_icon.gifenlarge_tooltip.gif
    Fig. Remove the crash pad lower panel (A)
  4. Remove the 2 screws (A) and the trip switch connector.
  5. Remove the crash fascia panel (B).

    0996b43f80e41e87.jpg
    enlarge_icon.gifenlarge_tooltip.gif
    Fig. Remove the crash fascia panel (B)
  6. Remove the screw with the ignition in the ON position (IG ON) and disconnect the 6P connector.
  7. Remove the ignition switch (A).
  8. Installation is the reverse of removal procedure.

    0996b43f80e41e88.jpg
    enlarge_icon.gifenlarge_tooltip.gif
    Fig. Remove the ignition switch (A)
Specific to:
Hyundai Accent 2006-2008
Hyundai Azera 2006-2008
Hyundai Elantra 2006-2008
Hyundai Sonata 2006-2008
Hyundai Tiburon 2006-2008
  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Remove or disconnect the following:

    The negative battery terminalThe crash pad lower panelThe ignition switch after loosening the screw with IG ON and disconnecting the 6P connector
  3. Installation is the reverse of the removal procedure.hope this helps it is off autozone website
0helpful
2answers

2001 hundai accent cannot unlock car doors with key. It worked on doors lastmonth. Have used lock deicer, wd-40 to no avail. Key works in ignition & trunk.

dose the key turn in the lock you could have a worn door lock where the plastic link bar on the back of the barrel gets a bit worn and just dosnt pull the link bar up enough , you realy need to remove the door pannel and really look at whats happening to the lock from inside the door checking the movement when you turn the key to unlock position you may even take up any play on the link bar to the latch lock by putting a slight bend in the bar to take up the slack
0helpful
1answer

What's your problem?2008 Hyundai Accent GLS only goes 20 miles an hour

Sounds like you may have a stopped up catalytic converter,low fuel pressure,or a motor about to die...
0helpful
1answer
0helpful
1answer

Hello i have a 2008 hyundai accent gls. it has

Get it scanned. You should be under warrantee. Otherwise most auto parts stores will do this. Could be as simple as a loose gas cap.
0helpful
1answer

User manual of Hyundai Accent GLS 2002

i would go to a dealer and get it they go by vin #s thats your best bet/ Please rate my response thank you very much
6helpful
2answers

My brake lights do not come on when i hit the brakes

If bulbs are ok it will be the brake light switch, or possibly the wires to the switch that have been knocked off with your foot. Push the drivers seat right back and get your head down under the dash. There may be a small panel that requires removal so that you can see up to the switch. Its directly in line with the brake pedal and has two wires going to it. Remove the connector and link the wires with a bridge wire. Switch ignition on and check lights. If they are on replace the switch or adjust so that the centre pin that comes out against the brake pedal is further away but is being pressed when the pedal is released.
Cheers John
Not finding what you are looking for?

104 views

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...