What wires are in the ignition switch harness of 1996 dodge intrepid

SOURCE: 1996 dodge intrepid 3.3 transmission wont shiftout of first gear

two issues here. this may be a low fluid issue. i would check the level of the fluid first. the next issue could be a blown shift solenoid. these are located inside of the transmission pan.also, check the filter as well.(transmission filter could be clogged)

SOURCE: 1996 ignition switch-what wires to check power on

ignition switch may be worn or a loose exciter wire [to starter] thats the small terminal on starter motor you can bridge it to the posative [power] on the starter it should start!
if it does start just work back from there to ignition look for broken or loosse connection
if that all is ok it will need ignition switch

SOURCE: Break Light wiring diagram for 1998 dodge ram 1500

haynes repair manual has a brake switch diagrame

SOURCE: Dodge Intrepid 1996 Water Pump Replacement Needs

a timing belt. the water pump uses it to turn it and you got to take it off to change the pump anyway so you might as well get a new one.also the hydralic timing belt tensioner should be replaced at the same time just to be sure.you will need anti freeze of course as well

SOURCE: 1996 Intrepid: firing order for 3.5 1996 dodge intrepid...

For the 1996 Dodge Intrepid 3.5L SOHC V6

Firing Order:
1-2-3-4-5-6

Cylinders:
......(back)
1........3........5
2........4........6
.....(front)

Ignition Coil Connections:
(back)
6....3
4....1
2....5
(front)

Let me know if this helped, or if you have additional informtion or questions. Feel Free to contact me at FixYa.com!