SOURCE: i have a subaru legacy outback, abs light comes on
one of your abs sensor is bad or the abs motor,go to local shop to diagnose which sensor,shop usually charge $ 60 to diagnose abs system,good luck, let me know ..
SOURCE: My Subaru Legacy Outback won't start and the
Starters don't click.
Solenoids click.
So remove push-on connector from Solenoid wire.
Should be clean, secure & relay bracket grounded.
Connect a jumper wire between battery positive terminal & the exposed terminal on the solenoid.
If starter motor now operates then it's the ignition switch.
If starter motor does not operate then replace solenoid.
SOURCE: 1997 subaru legacy outback knock sensor location
Hiya,
Here you go:
2.5L Engine
To Remove:
Hope this helps...
Cheers,
SOURCE: location knock sensor
The knock sensor is located on the top of the engine block almost hidden from view by the intake manifold. It is almost directly below the spot where your throttle cable connects. It will have a bolt running right through the middle of it and a single wire coming out of it.
SOURCE: how to set timing on a subaru outback legacy 2.2
ignition timing is not adjustable,
the valve timing marks are at 12o'clock on both camshafts and crankshaft
184 views
Usually answered in minutes!
×