Is there a time frame on waiting for a transmission to be installeds and found?
SOURCE: chyrsler sebring lxi 1995 2.5 v6 24 valve
ok this sounds easy when you ran the vehicle the computer controled the idiling motor now that you replace the idiling motor the computer hasnt been reset to except the new parameters
once you reset computer this should bring the idle back down to its specified idle
you can also adjust back of gas pedel the idle cable and on the throttle body by the idling screw
SOURCE: 1995 chrysler sebring lxi
there are four 18mm bolts on the opposite side of dust plate.once u remove thoe bolts,you'll have to either use a slide hammer, or the old fashion way a big hammer and smack it side to side.the whole hub and wheel bearing assembly will come out.The dust sheild is in between the hub and axel once it comes apart u will understand.
SOURCE: How Do i Remove Dash Board Speakers From A 1997 Chrysler Sebring
all u do is pop them out, they pull upu may need 2 use a screwdriver or something to get them started, then u follow the wire down and theres a lil connecter u can pull
SOURCE: 2004 sebring lxi 2.7L V6, engine revs when slowing
I had a similar issue with my Sebring. I took it to the dealership and they just "rebooted" my computer system. They said the computer was getting confused and having problems downshifting. I would check with them. It only took a few minutes at the dealership to reset it. I was relieved that it wasn't something major!
Hope this helps.
-LH
SOURCE: 1997 Chrysler Sebring LXI V6 Coup Belts - inside or outside?
There should be a sticker under the hood that shows the belt routing. If not go to a parts store, Autozone ect and they can look it up and print it out for you
74 views
Usually answered in minutes!
×