When i turn on a/c, it only blows hot air. The clutch and compressor seem to work fine.
SOURCE: Cabin Air Filter - 2004 Mitsubishi Endeavor (Where?)
IT IS IN BEHIND THE GLOVE COMPARTMENT YOU HAVE TO TAKE IT OUT BY UNSREWING AND START FROM YOUR RIGHT SIDE
SOURCE: 2001 Mitsubishi Montero Sport, ac not working
is ac low side pipe/hose cold?(large line)near firewall? if so u have a temp door actuator motor not working
SOURCE: trying to change spark plugs
THEIR ARE ABOUT 9 BOLT TO REMOVE THAT SUPPORT THE INTAKE. 2 ARE IN THE REAR IN THE CENTER OF THE SUPPORT BRACKET THE 5 THAT ANCHOR THE INTAKE ITSELF AND 2 UNDER THE INTAKE THROTTLE BODY. ( 12MM) 3 HOSES ON TOP OF THE INTAKE TO REMOVE AND 1 SENSOR TO UNPLUG OR UNBOLT (8MM)THE ONE ON TOP OF THE INTAKE (TOP LEFT REAR). THIS WILL GIVE YOU ACCESS TO THE REAR PLUGS.
REMOVE THE SENSORS BRACKET OR HOLDER ( ON THE LEFT JUST LIFT UP TO REMOVE) AND SWING THE INTAKE TO THE RIGHT. UNPLUG THE PLUG MODULE THEN UNBOLT THEM (10MM).
SOURCE: 2005 Mitsubishi Endeavor Air Conditioning Drain Leak
Water dripping on the passenger side is usually accompanied by rushing water noise during sharp turns. This is extremely common on Endeavors, and is caused by a blockage in the drain of the AC system. It can be caused by leaves/debris or insulation foam that has come loose. There is a bulletin to remove the foam and any leaves/debris under warranty (5y/60k) and install a cabin filter to prevent recurrence.
SOURCE: Mitsubishi Eclipse Ac and heater problem
cold air on passenger side of car and warm on drivers, why
1,097 views
Usually answered in minutes!
×