How do you drain the gas out of a 2006 Nissan Maxima 3.5 SL

The slip light illuminates when a traction control component fails or sends incorrect info to ecm. Normally problem is at wheel speed sensor, DO NOT REPLACE SENSOR UNLESS PROPERLY DIAGNOSED AS DEFECTIVE. FIRST all reason normally is due to gathering of debris at sensor , I would raise front wheels and support vehicle with jack stands (SAFETY FIRST) Remove wheels and locate wheel sensor and clean as needed. and see if this corrects problem. if problem still persist. then check for stored dtcs and start from there


I’m happy to assist further over the phone at https://www.6ya.com/expert/james_9ddabbbc483e2add

If it is a removable plug on the tank to let out all the fuel th short is no. You would have to manually remove the fuel from the tank by way of a pump. The only way to access it would be remove the rear seat and accss thee tank by way of the fuel pump. It' an all in one module. Pretty simple to remove but I recommend extreme caution while doing any thing with fuel. Its the vapors that are highly volatile. Proceed with caution

You can by pass it, but regular bulbs are not plug and play. You also won't find plugs that fit the housing for the lights. Different set ups.

Can you be a little more specific in what you did with the relay switch I don't understand. Did you swap it with another relay?

If your replacing the fuel pump, you don't need to drain it. You access the pump from under the back seat. There's no drain. Once you get the pump out, you can siphon it out. Have plenty of rags handy taking out the pump. You will spill some gas.

On the internet -Google it

Try You Tube Video for the motor you have

Hello
The engine and automatic transmission in this vehicles drive train are fully electronically controlled by a computer called the PCM (Power Train Control Module). Whenever a problem like this occurs the computer stores a record of the problem (there are of course some exceptions to this, like the fuel pump, engine coolant temperature sensor and MAF sensor for instance) in the form of a fault code in its memory, to read these fault codes you must have the systems memory scanned with a special tool. Once the fault code(s) are read you then must perform the appropriate diagnostic testing to find and resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL A TRAINED TECHNICAIN HAS DIAGNOSED THE PROBLEM TO AVOID SPENDING YOUR HARD EARNED MONEY ON PARTS THAT MAY NOT CORRECT THE PROBLEM

the fuel sending unit is w/the fuel pump in gas tank.try checking for blown fuse under dash if not one there try inder hood, black box usually on drivers side.lift cover @ inspect. hope this helps!!!

No easy way. Tank needs to be dropped, fuel disposed of properly, tank cleaned. Also recommend doing a fuel injection system cleaning. Try to find somebody who has a motorvac injector cleaner. That cleans everything the best

2002 Nissan/Datsun Maxima 3.5L SFI DOHC 6cyl



Fig. View of thermostat and components




Fig. View of thermostat and components-2002-2006 Maxima

1. Before servicing the vehicle, refer to the Precautions Section.
2. Drain the cooling system.
3. Remove or disconnect the following:
   
   Negative battery cable If equipped, engine cover On 2002-2006 Maxima, air duct and air cleaner case On 2002-2006 Maxima, drive belts Water drain plug on water pump side of cylinder block Lower radiator hose Water inlet and thermostat assembly
   
4. To install, reverse removal procedure
5. Install thermostat with jiggle valve facing upward.
6. Run engine and check for leaks

Good luck (remember rated this help).