Why won't it stay on the reset switch for a2000winstar

May need a new window regulator installed.

The gas u put I'm the tank was high octain if it was it was making the engine fire to early replace the gas and it should wor properly

bad pressure switch

look this link


http://www.neverhotwired.com/vehiclekillswitch/

Done cars have a kill switch if they are low on oil. Check your oil. If the oil is good, it may be the ignition switch.

CHECK FUEL PRESSURE SHOULD BE 39 PSI REPLACE FUEL FILTER AND FUEL PUMP RELAY IF FUEL PUMP STILL TURNING OFF FUEL PUMP COULD BE FAILING.

When you say it won't start, do you mean it cranks but won't fire, or it just won't crank? If it just won't crank, you could be having an issue with the starter relay. The often become intermittent before failure. Many owners do not know there is a starter relay because it was added as a recall item i order to protect the iginition switch from burnout. The starter relay is located in the very front of the engine compartment, just to the left of the battery, on the back side of the radiator crossmember.

check master switch,window motor-regulator

Hi there?
The brake light switch is faulty or is NOT secured. When the brake pedal is released it pushes the pin on the brake switch to switch the lights off. If the pin is not getting pushed in proparly then the lights stay on. check the switch. Good luck................

there are 2 sensor on the carb . you may need to replace both to find out whiche one it is . try this also give it gas while starting and when it starts you will have to keep your foot on the gas a little to keep it running if it runs that way its one of the 2 senors .