The reset switch will not stay in when I reset it why

Throttle Position Sensor Replacement - YourMechanic

www.yourmechanic.com > Auto Repair and Maintenance Services

When the throttle position sensor is repaired or replaced, it will need to have the minimum idle speed reset to factory specs, and the trouble codes will need to be ...

P0122 Code - Throttle Position Sensor/Switch A Circuit Low ...

www.obd-codes.com/p0122

Also includes links to other forum threads discussing the code. ... P0122 Code -Throttle Position Sensor/Switch A Circuit Low Input ... I have 6 codes that stay the same. all the rest don't stay after reset. codes are P0106,P0107,P0108,P0122 ...

2002-2005 Kia Sedona Throttle Position Sensor ... - YouTube

? 1:51
https://www.youtube.com/watch?v=JRwUK2Iem9s
Jul 11, 2011 - Uploaded by Jerry Ferguson
Kinda important - Before removing the old throttle position sensor, snap a photo of its position with your phone ...

Reset the Tire pressure monitoring system light. The reset button is located under the steering side under the finish panel. You have to bend down to see the button.
Operate the tire pressure warning system reset switch only after the inflation pressures of all 4 tires have been adjusted on the vehicle.
To initialize the system, press and hold the tire pressure warning system reset switch for 3 seconds or longer with the power switch turned IG-ON

This switch would be located in one or two places. If you have Air-ride suspension the Inertia switch is usually close to the Air-ride switch. Sometimes there is a plastic cover over the switch in the rear cargo area. The rest of the time the Inertia switch is in front by the front seat kick panels.

There is a reset button on the switch, just press and hold for a second or two and the reset is made.

find your reset switch and reset it

Automotive circuit breakers reset themselves. They will stay open as long as a short exists in the system they provide power to.

You need to replace that switch for it doesn't hold the circuit closed for you

DID YOU TURN ON IGNITION SWITCH ON AND SLOWLY DEPRESS AND RELEASE THE ACCELERATOR PEDAL 3 TIMES WITHIN 5 SECONDS.IT WILL TAKE LONGER TO RESET DETERMINE HOW LONG YOU LET THE OIL LIGHT STAY ON.WHEN YOU TURN ON SWITCH 5 SECONDS DEPRESS AND AND RELEASE ACCELERATOR 3 TIMES.IF DONT RESET.TURN OFF SWITCH.THEN TURN BACK ON.YOU MAY HAVE TO DO IT SEVERAL TIMES.LET SWITCH REST SOME TRY AGAIN.IT WILL TAKE A WHILE.WHEN EVER CHANGE OIL SOON LIGHT COME ON RESET IT THEN AND CHANGE OIL.DRIVE IT ON A WEEK OR TWO TAKES LONGER TO RESET.

if you found the switch, simply press down to reset..check those fuel lines for damage first.

Must have engine computer scanned to get codes and determine cause of check engine light. Low tire light probably needs reset. Open passenger door and remove panel on side of dash. Reset switch should be located in that compartment.

under the dashboard on the drivers side. look at the brake pedal lever. there should be a switch attached. push switch in and twist to remove. then pull the button as far out as it will go. while holding brake pedal down reinstall switch. then pull pedal up to top. this will reset the brake light switch. if they stay on still, then just replace the brake light switch.