2003 Hyundai Accent Logo

Related Topics:

Christen Roe Posted on Mar 06, 2017

How to reset dash clock on 2003 Honda accent

The clock is on and works but when I try to reset it it doesn't seem like any of the buttons work

5 Related Answers

Anonymous

  • 962 Answers
  • Posted on Nov 26, 2008

SOURCE: AC works, Heater not working, 2003 Hyundai Accent.

Check the coolant level, do this with a cold engine. Or if you have recently used it. let it cool down for about 25 minutes before removing the radiator cap. if it is low, refill with coolant. If it does not, check your thermostat. Or better yet replace your thermostat. Be sure to get the right one . the same degrees as your old one. Just ask the teller to give you one for your engine size and car Model.And year.See where the radiator cap is. Then drain some coolant to where it will not spill from the radiator cap. Remove the hose nearest the radiator cap and you will get to the thermostat housing. Remove the housing and note how the thermostat is placed. Take of the thermostat housing and the old thermostat. Clean the housing and around the hole where the thermostat goes of any deposits. Get some grease and cover the new gasket with grease on the housing to hold it in place. replace the New thermostat and make sure it is flush with the engine and the housing. If it is off , you could break the housing upon tightening the housing.replace the hose and refill with coolant slowly to eliminate any air spaces.. Also check the coolant reservoir and fill it to the indicator line. Restart the car and chek for any leaks. Then check the heater after the engine heats up. If that does not do the job it could be the temperature sensor or the heater core.The heater core will take more time to check and clean or replace.

Ad

Frank Magliocca

  • 1461 Answers
  • Posted on Dec 06, 2008

SOURCE: I have a 2003 Hyundai

disconnected or cracked vent tubes

gfischer21

George Fischer

  • 236 Answers
  • Posted on Jun 17, 2009

SOURCE: Accent rev counter not working

replace the counter or check to see if the cable attached to the back end isnt stripped, it should be square

Anonymous

  • 86 Answers
  • Posted on Jul 27, 2009

SOURCE: I have a 2003 Elantra the light inside don't work

did you check the fuses

Anonymous

  • 34 Answers
  • Posted on Apr 17, 2010

SOURCE: I have a hyundai accent 2001 2 doors .my dash

you might need to look at the wires on the back of the radio, there might be an inline fuse, also you best have a look at the main fuse panel in the car and see if the one for the radio and clock has blown

Testimonial: "yes that was it the fuse from main panel; Thank you"

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2009 Hyundai Accent My horn and radio doesn't work. I've checked the dash fuses and relays under the hood, I need help please!

The radio doesn't from the buttons on the steering wheel ? The clock spring inside the steering column could have an open in the wiring ! The clock spring allows you to turn the wheel from full left to full right while keeping the horn an radio control buttons connected electrically with wires going down the steering column . Do you have a Air bag light lit on the dash ? How cars clock spring works
0helpful
1answer

I want to know how to reset my clock in my 2005 Honda inspire car. the dash is all set out in Japanese.

Don't know your car but clock on a lot of cars is controlled by the other button near the odo reset - press and hold till clock flashes, these buttons are normally near speedo and rev counter normally ignition on engine off then sometimes your button turns left or right to adjust. Either that or search for images of your car and it's clock.
0helpful
1answer

How do I set panel clock time in hyundai accent 2006? The buttons doesn't seems to work. I press them, but nothing...

You have to take it apart to fix it. Bad contacts in the clock. They can be cleaned up to work, but not for long. Replace it . No fuse for the time set buttons.
1helpful
1answer

Subaru Forester, 2003. clock light and dome light not working (clock works, just no light at night). all other dash lights appear to function. i replaced fuse marked 12 in engine fuse panel, described...

The clock works, correct? It is just not illuminating when your headlights are turned on? If this is the case then it is most likely that you have 2 burned out bulbs. The forester clock bulb is Sylvania bulb part #2723

Hope that helps! I have a bunch of clock related info on my website www.autoclockrepair.com. Let me know if I can be of assistance.
0helpful
1answer

NO CRANK. NO STEREO. NO CLOCK.

I think that your battery is dead. Try jump starting the car. Be careful that you hook the jumper cables correctly, red to positive[the + on the battery] black to negative[the- on the battery].
0helpful
1answer

Accent rev counter not working

replace the counter or check to see if the cable attached to the back end isnt stripped, it should be square
1helpful
1answer

Reset radio but can't reset clock

just press the clock button for a few seconds then press it again for few seconds and it should stop blinking once it stops blinking press the clock button down again and hold then once it starts blinking release the clock button and adjust the hours and minutes
Not finding what you are looking for?

210 views

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...