2004 Mercedes-Benz E 320 Logo

Related Topics:

Reggie Sinkler Posted on Mar 01, 2017

2004 MERCEDES E320 READS MALFUNCTION BATTTERY ICON WITH MESSAGE VISIT WORKSHOP, for weeks while car functions flawlessly.

1 Answer

David Redbeard

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that hasĀ over 10 points.

  • Contributor 32 Answers
  • Posted on Apr 07, 2017
David Redbeard
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that hasĀ over 10 points.

Joined: Nov 18, 2015
Answers
32
Questions
0
Helped
25355
Points
80

Your alternator is not putting out enough power to recharge your battery.. Your battery will eventually drain.

5 Related Answers

Anonymous

  • 357 Answers
  • Posted on Jun 26, 2008

SOURCE: Mercedes Benz C180 Fault Message Brake Assist.Visit Workshop BAS

Hi there

BAS is the Brake Assist System and if there is a malfunction it would only come into play in an Emergency stop while applying full pressure. BAS applies full braking force because people tend to lighten up their pressure on the pedal in these situations. I would suggest that the best thing to do is go to a Workshop or Service Center and have it checked out. Please remember to put a good rating on my profile.

Kind regards
Dustin Ellse

Ad

Anonymous

  • 405 Answers
  • Posted on Dec 14, 2008

SOURCE: method of charging a 2004 Mercedes E320 battery

It is always safer to charge the battery out of circuit, Removal of one cable will insure you can safely charge without hurting electronics on board. Generally if your battery is already sufficiently charged it acts like a capacitor in the circuit and will prevent damage, but many battery chargers do not always put out a pure dc voltage and this can damage electonics.

Anonymous

  • 84 Answers
  • Posted on Mar 02, 2009

SOURCE: Service Brake message

Hello, You probably have brake pads that are worn down to the sensors. You will need to take it to whomever does your repairs. It could be either the front or rear pads or both.

If you find this info to be correct, please enter a (fixya) rating
Thanks, Gator241

David Shaub

  • 2994 Answers
  • Posted on Nov 27, 2009

SOURCE: I sometimes get a battery symbol and visit

Tighten the alternator belt.

Anonymous

  • 1 Answer
  • Posted on Dec 14, 2010

SOURCE: crankshaft sensor Mercedes E320

i have mercedes 94 e320 was run ok .but after engine wash
first coil no sparking ,and a the second quit too ,running only whit the third coil ,,i changed all 3 coils but runnig a same,,no sparks on those front 2

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I have a Mercedes c270 2005 model it flashes esp fault visit workshop

ESP is Electronic Stability Control! This is traction control and is controlled through the ECU, take to Mercedes garage to read the fault codes and resolve the problem!
0helpful
1answer

My E320 " Engine oil Sensor "visit workshop light is on".

Mercedes -benz E320 w211 Oil level big red light will not go out.changed the sensor still on. Also had low fuel pressure I don't know why but when I Changed the fuel pressure sensor my oil level red light went out.
2helpful
2answers

Dashboard message to visit workshop w/ picture of battery

Your battery are okay but you may have an alternator/generator problem, it's not charging back electricity to the battery. That's the common interpretation of that battery warning light on the dash...

6helpful
1answer

2004 e320 just replaced the front and rear brakes and now I get the ESP malfunction visit shop.

MERCEDES BENZ DEALERSHIP HAS TO REPROGRAM THE ANTI LOCK BRAKE SYSTEM AND ELECTRONIC STABILITY CONTROL SYSTEM.IF YOU DISCONNECT BRAKE PAD WEAR SENSORS WHEN REPLACING BRAKE PADS. THE ABS BRAKES AND ESP SYSTEM HAS TO BE RESET TO TURN OFF ESP LIGHT.
0helpful
1answer

My mercedes E320 write in the display that i shall visit workshop because of break lining wear, is it dangerous to drive the car now? and what is exactly break lining wear?

Your car has a sensor on the brake components which detects when there is low brake life. Assuming your brake system is functioning normally; there will be no initial safety hazard/danger. You should have a professional inspect brakes ASAP because if you wait too long there may be additional damage that could have been avoided with a more expedited inspection.
0helpful
1answer

2003 E320

The E320 in that year range upto approx 2005 uses an auxiliary battery to operate the brake pump when main battery supply was lost or low. The low battery warning you describe can be caused by the aux battery being low. This battery is a small 7Ah battery mounted under the pollen filter in the engine area.
0helpful
1answer

2003 E320

My car keeps displaying a picture of a battery Visit Workshop. How do I clear the code?
22helpful
1answer

Mercedes Benz C180 Fault Message Brake Assist.Visit Workshop BAS

Hi there

BAS is the Brake Assist System and if there is a malfunction it would only come into play in an Emergency stop while applying full pressure. BAS applies full braking force because people tend to lighten up their pressure on the pedal in these situations. I would suggest that the best thing to do is go to a Workshop or Service Center and have it checked out. Please remember to put a good rating on my profile.

Kind regards
Dustin Ellse
Not finding what you are looking for?

497 views

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...