Where is camshaft sensor located on 2004 isuzu rodeo V6 3.5ltr

camshaft position Sensor location???

Isuzu SUV Forum https://www.planetisuzoo.com > threads > camshaft-po...
Jun 23, 2009 - It is located on the inside surface of the front of right cyl head. 2000 Rodeo LS (stock). 78 T/A (far ...

SOLVED: Where to locate the camshaft sensor on a isuzu

Fixya https://www.fixya.com > ... > Isuzu > Rodeo
1 answer
It's on the inside of the cylinder head at the rear of the engine. Will be hard to see it because the intake plenum hides it. where to locate the camshaft ...
Doesn't include: LS ‎' Must include: LS

Where is the camshaft position sensor in my 2002 Isuzu ...

JustAnswer https://www.justanswer.com > Car Questions
May 13, 2020 - My son is a mechanic and the Haynes manual says it's under the lower intake. Need to verify. Share this conversation.
1 answer · Top answer: you are welcome

• 
  

  Isuzu Rodeo: WHERE IS AND HOW TO MEASURE THE ...

  https://www.justanswer.com > Car Questions
  Mar 30, 2013 - If you are just testing the sensor, you can check the cam sensor signal at the ECM on pin 11 of connector number 2. It is the same blue wire.
  
  ..

2004 no vin code posted nor the 8th VIN digit for engine code
so answers get 10x harder, lacking that one fact. USA car?
Coin toss 1:
learn the real name of engine, first
6vE1, 4 cams, and last year has VVT, (not trivial that)
and has 2 Cam sensors. to make VVT happy,. dig?
weve answered this many times here, over and over
did the scan tool tell you its bad.?
its on the rear of both heads,

the post above is wrong, he shows the 6vd1w engine,
here just for fun, again i post all V6,s just for you, and others too lazy to search or learn engine REAL NAME.

ill do all 3 V6 engines now.

Here's a link to your sensor location. Where is the camshaft position sensor located for 1999 3 2L V6 Isuzu Rodeo

Its right below the condenser housing underneath the distributor cap

they are located on the back of the heads

here

P0341 ISUZU - Camshaft Position Sensor Performance
Possible causes- Faulty Camshaft Position Sensor
- Camshaft Position Sensor harness is open or shorted
- Camshaft Position Sensor circuit poor electrical connection
- Faulty starter motor
- Starting system circuit
- Dead (Weak) battery

it is located on the inner rear section of the left hand head (left side of vehicle) under inlet manifold dont need to remove inlet manifold
and connector must face rearwards to work correctly

In the drivers side head towards the front of engine. See myisuzuparts.com

Where Is The Camshaft Position Sensor Located On A 1999 Isuzu Rodeo?