SOURCE: 2007 Nitro will not start
asd/ignition relay shorting or possble pcm/gem failure. Depending on mileage, I would return to dealer as this is a warranty issue.
SOURCE: 2008 dodge nitro 3.7 engine. The engine missfires
Have it checked for trouble codes sounds like it could be an injector problem or something as serious as a loose rocker,maybe try a crank&cam shaft position sensors
SOURCE: 2008 dodge nitro change oil light how to turn off ...
Directions are in the book, but you would put the key in and turn it all the way, just don't start engine. Pump gas pedal all the way to the floor 3 times slowly, but it has to be with 10 seconds. Turn key off and when you start again, oil changed chime and warning should not be on. If it is, try again.
SOURCE: On my 2007 Dodge 2500
there is no relay in that box that is called the tipm or totally integrated power module. that module is controlled by a computer and should be checked with a scanner to see if you have a code for the a/c. i m having the same problem i have been told it could be low freon but can not get the clutch to engage to check the high and low pressure. Also read where it may be the diode in the clutch on the ac compressor if you have a multimeter probe the compressor a good compressor will read somewhere between 3.5 and 4.0 anything else and clutch needs to be replaced. other possibilities may be the high or low pressure switch on the line. on myh 2006 2500 diesel it is located near the plug for the compressor on bottom side of motor. hope this helps.
SOURCE: radio and power outlet stop working io suspect
in the fuse panel under your hood in slot 7 is were the problem is, its not a fuse its a 13amp circuit breaker.
997 views
Usually answered in minutes!
×