Hi 04 chrysler voyager I would like to bi pass it remove it just need to drive my car cheers

if you have one it was an option on the 2.5 towards back lower engine by fire wall ----follow exhaust pipe to engine --turbo bolted to exhaust pipe and exhaust manifold the photos show location in link https://www.chryslerforum.com/forum/chrysler-voyager-town-country-21/crd-2-5-engine-transmission-removal-overhaul-26604/

Hi. I need help. I need radio code.

Try resetting it with a scan tool or contact a Chrysler dealer.

What model Chrysler is it?

sounds like the blend door is stuck

P0700 Chrysler Transaxle Control System Malfunction I'd take it an have it checked out , could be a sensor or the transmission control module !

Front differential that is inside the transaxle

Normally when you rebuild that transaxle you
do not remove the diff or change it's bearings

if you open the hood and look on the pass side strut tower there should be a sticker with that information on it as the gap is diff for different engines

it could be the CV joint is faulty, check the rubber boot on the drive axle on the near side front wheel to see if it is split or completely destroyed,if it is damaged the dirt has got into the CV joint & caused the damage & the CV joint will have to be replaced........hope this helps......cheers

My 98 Grand Voyager 3.3L engine # is located on the rear of the cylinder block, below the cylinder head, your 99 should be the same location. It contains the last digit of the model year, manufacturing plant, engine, usage (car, truck), month/day, serial code (last 8 digits of vin). countrycurt0

There should only be two bolts on the back of the caliper holding it into the knuckle. Removing those two bolts should free the caliper. In fact I believe they're 12 or 13 millimeter bolts.