Removal of paneling to get to third brake light on h3 hummer

Greg Bernett

• 2993 Answers
• Posted on Apr 04, 2009

SOURCE: How to cchange the third brake light bulb

1992–98 GRAND AM AND ACHIEVA

1. Disconnect the negative battery cable.
2. Pull the center high-mount stop lamp cover to disengage the retaining tabs.
3. Unfasten the lamp retaining screws.
4. Remove the sockets using a suitable prybar to release the retaining tabs.
5. Detach the bulbs from their sockets.
6. Using a suitable prybar to release the tabs, remove the lamp lens. Fig. 14: View of the center high-mount stop lamp assembly — 1995 Grand Am and Achieva shown

SOURCE: need 02 trailblazer third brake light removal

Open the full hatch.
Pull down the weather strip near the rear dome light.
There should be a wire with a connector in it. Disconnect it
Close the full hatch.

Open just the window hatch. There is 1 screw on either side of the bulb housing.

SOURCE: how do you remove the front tow hook brackets on a 07 hummer h3

put the bolts back in and tap them with a hammer it will push the bracket out and then take the bolts out 

SOURCE: BRAKE SYSTEM FAILURE

well what could of happend they probably put the battery on backwards and blew out a fusible link.The links run thru the wires by the battery and behind the alternator check it out Good Luck keep me posted

SOURCE: how to replace h3 hummer climate control light

how do I replace lights in climate controls they went out?