I recently put in new brake pads and front bearing then suddenly the Abs light doesnt switch off in the dashboard. What could be the problem?

SOURCE: 2001 Chevrolet Silverado

Bad sensor in one wheel, they are part of the wheel bearing. Could also be a bad abs computer module, either way, not cheap.

SOURCE: brakes

Did you replace the brake pad sensor? If they have not been replaced then you will continue to see the dashboard telling you to replace the brakes.

SOURCE: abs light on

They had to disconnect the abs in order to change the pads so it set off the abs light. you can just drive for a while and it might go away or you can disconnect the battery for 10 seconds but be careful the car player might ask for the code in order to play it.

SOURCE: 2006 grand caravan abs and brake light on and off

If the ABS lite is comming on, the module is detecting a problem in that system. There will most likely be a code in the computer. take it to your dealer and have it check. The most common problem i see in these is a failed speed sensor.

SOURCE: ABS brake light comes on.

No there is no reset, sounds like you have a bad ABS sensor on one of the wheels. Only way to tell is to get it to a brake shop or dealer to check it. Good luck dont forget to rate.