How many pound of pressure i need for the rod bearing for a acura rxs 2005

already answered here, 26 or 29 :>D

What are the torque specs for crankshaft main and rod - Fixya

https://www.fixya.com > ... > Buick > LeSabre
Sept 21, 2012 - The connecting rods torque to 29 foot pounds. ... Where is the eng control module in a 2005 Buick Rendezvous ultra 3.6 eng.
SOLVED: I need torque specs. for rod bearings and main - Fixya
Jun 2, 2011
Torque specs for intake on 2005 buick rendezsous - Fixya
Sept 7, 2019
Torque spec for1997 3.8 buick rod and mains - Fixya
May 22, 2012
What is the torque specks for a 3.8 lt v 6 rear main cap 1987 buick ...
Nov 14, 2019
More results from www.fixya.com

More here

https://www.google.com/search?q=05+Buick+Rendezvous+Ultra+3.6+piston+rod+torque
..

17 ft lbs but you have to use torque angle meter Plus 90 Degrees and you need to use this: Plastigauge, Plastic Precision Clearance Gauges (plastigaugeusa.com)

You mean drive shaft? 100 lbs.

29 pounds on rod bearing
42 pounds on main bearings
thank you and please reply

How do you know that you have Low Oil Pressure?

Are you trusting the Gauge or putting an In-Line Gauge?

YOUR GM GAUGE CLUSTER is known to have BAD or DEFECTIVE STEPPER MOTORS...

If you put the In-line Gauge on and see that you have Good Pressure, then what you need to do is rebuild your Instrument Cluster.

MAKE SURE YOU USE X27.168 Stepper Motors... The Cheaper CHINEESE STEPPER MOTORS are black and are defective.

The X27.168 Stepper Motors are WHITE and will last for as long as you own the Truck.

Order 6 Stepper Motors and do them ALL at the same time or you can pay someone $95-$200 to rebuild it for you...

engine is shot replace.throw rod and main bearing and rod is bent or broken.

main bearings = 38 ft pounds

rod bearings = first tighten to 13 ft pounds then an additional 1/4 turn

this is per mitchell on demand

main bearing caps 56-62 foot pounds connecting rod caps 1st pass 17 foot pounds 2nd pass 32 foot pounds......................HAVE FUN

if you are talking about the pilot bearing in the flywheel?... then pack the area behind the bearing with grease then pound a rod the size of the bearing opening into the hole of the bearing. this pressure will force the bearing out. Or you can use a slide hammer with craw tips to extract the bearing.

The info I have at had shows 60ft pounds for the Main Bearing Cap Bolts & 34ft Pounds for the Connecting Rod Bearing Cap nuts. For Bearing cap the sequence is as follows: When looking at underside of engine (bearing cap or Mono-block) and front of engine (harmonic balancer) to your left.

8 - 4 - 1 - 5

7 - 3 - 2 - 6

I hope this may have helped,
Tom