My toyota yaris is cranking but there is no spark, how can i fix the problem

Hi Dan
cranks or does not crank fast,??? the starter motor spins the crank shaft fast, 300rpm in fact and must first.
or it cannot be started , my Wangler 6speed ,M/T push starts and gravity starts too. but no the A/T box fitted Funcargo
1999 to 2005 not one in USA at all
one answer fails to crank, battery dead or A/T not in park or neutral.
2nd answer, cranks fast but will not start.

• spark dead.
• fueling dead or bad fuel. wrong fuel class, diesel in to petrol ?
• fueling too much flooding , crank with wide open throttle WOT.
• engine bad, cam belt slipped or snapped at 100km and did.

wiki facts, not told. you, you have real Japan (JDM) car?
The Toyota Yaris Verso is a mini MPV produced by Toyota using the Yaris nameplate from August 1999 to October 2005. In Japan, it is known as the Toyota FunCargo (Japanese: ??????????, Hepburn: Toyota Fank?go). It is built on the same NBC platform as the XP10 series Yaris/Vitz/Echo. The FunCargo/Yaris Verso was replaced in Japan and Europe by the Ractis and Verso-S, respectively
3 engines (some my be belted cam, I'm too lazy to read then all not told you)
Petrol:
1.3 L 2NZ-FE I4 (NCP20/22)
1.5 L 1NZ-FE I4 (NCP21/25)
Diesel:
1.4 L 1ND-TV turbo I4 (NLP20/22)

the EFI works just like that, if ECU sees no spark it cuts fuel fully./
to end crash and burn as seen on TV and by laws here USA
My 2009 1kr Toyota Yaris we check all fuses first (a test)
then we scan the PCM using a scan tool. eg: omg CKP sensor or CMP sensor is dead ,. if seen.
have a shop fix this or buy the tools and learn how.

1.5L I4 , engine.
how man miles
buy it used and dead??>???????????????????????
chain drive cams, so I guess they didn;t scream for help just before it died right (chain thrashing/)
this engine has 4 COP coils, are all 4 dead? the classic test?
or just 1, all 4 must spark , not JUST 1, see my drift?
if all are dead and fuses all good
the scan tool tells you why,
P03xx errors. 1 for cmp or 1 for ckp deathh
ckp crank sensor wires fell off or got heat by road hazards.
CMP is on cam end. not lose.

check and test battery -fuses-relay --check key for wear same with ignition cylinder-- recheck install of starter

Engine Will Not Start But Fuel Pump Spark and Compression Are Good
This link may give you some pointers ... good luck with your troubleshooting

Any codes? Could be the crankshaft sensor.

immobilizer issues , cam shaft position sensor and ignition module spring to mind
best run the fault codes to get closer to the sensor causing the fault

Visit the on-line store, known as reliable-store, they have the repair manuals. I'm sure you will get the solution of your problem.
Best Manuals

its use timing chain. and the mark is on the chain just follow the chain

look at the coil on the plug that isn't firing. May be bad.

check that the cam sensor rotor is on the camshaft properly and is adjusted to the correct air gap
if the dealer just did the overhaul then take it back to them