I have a 2003 honda accord ex that. I changed my motor. Now I have a check engine light with a blinking D light. After reading the codes ABCD solenoids and will not go in gerar.

SOURCE: 2003 Honda Accord Check Engine / Maintenaice Requeried

If you brought your car to Honda for service, they probably forgot to reset the maintenance reminder. If you took it to another shop, they probably did not know how to reset it. Anyway, the reset procedure is:

Put your key in the ignition
Turn the key to the II position for a couple of seconds
Then turn the key to the off position
Now push and hold in the odometer reset button
While still holding the odometer reset button, turn the key back to the II position
Hold for I think 10 seconds or so and your maintenance reminder light should reset it self.

SOURCE: check engine reads P0740 honda civic

I am sorry to bum you guys out, but this usually means the piston in the torque converter is bad. The converter needs to be replaced along with a transmission flush.

SOURCE: blower motor 1991 honda accord ex

the blower motor is located behind and under the glove box. its held to the blower housing by three screws. remove the three screws and the motor will slide down and towards you. to test the motor. apply power to the yelllow/black wire and ground to the blue/red wire. the motor should run. if not you prob have a faulty power resistor.

SOURCE: check engine light is on,

Could be as simple as a loose gas cap or cap seal or a bad o2 sensor. A falty cat. converter will also cause the check engine light to come on. Either way, you need to go either to a dealer or some auto parts stores will plug in the dioegnostic sensor and can tell what is wrong. your gas milage will suffer until you get this fixed. Your engine computer uses the inputs from your o2 sensers to adjust the fuel air mixture of the engine for optimum engine performance.

Iron

• 3018 Answers
• Posted on Jun 22, 2011

SOURCE: I have a 1999 honda Accord EX. The engine check

• If you can please list the code that was read and also the symptoms for me I may be able to give more specifics on the code itself. As for a misfire in any cylinder I will lists some things that are indicative of this.

1. Spark Bad fuel injector
2. plug
3. Plug wire
4. Coil
5. bad 02 sensor
6. bad computer.
7. out of gas
8. bad catalytic computer
9. burned exhaust valve
10. poor compression.

• Symptoms can be a hard to start engine.
• Hesitation or bucking when accelerating.

• A rotten egg smell from the exhaust can indicate a bad Catalytic Converter.
• If it has been a long time since a tune up then plugs and wires may be in order.

Testimonial: "I am still on the way to fix the problems in my car. But I think the information provided here is very helpful. "