Im trying to find the oil pressure sender on my 2002 mazada tribute 3.0 es

SOURCE: I have a Mazada 2002 mvp minivan. I can't turn my

My MPV has/had the same problem. Simply put the shifter up into Park and then press the outer end of the gear shifter away from you towards the dash/windshield until it clicks. While still depressing the shifter end, remove the key and it's in park. The microswitch is slightly out of adjustment. Good luck. I've been doing this for 2 and a half years and it's still working ok. Remember to let the attendant know if you leave the car with valet parking!

SOURCE: my 01 tribute es air bag flashes on and stays on.

you should replace your fuse. most likely theres either a short in it or just needs to be replaced

SOURCE: 2001 mazada tribute firing order

My sincere apologies for the delayed response.
I am personally going back to answer your unanswered questions.
I have only been a free contributor to this site for the past 4-months.

I do not know if you still need this information, but I am going ahead and answering it anyway.

For the 3.0L:
Firing Order:
1-4-2-5-3-6
Cylinders:
(back of engine)
1------2------3
4------5------6
(front of engine)

Let me know if this helped you, or if you have any additional information or questions. Feel Free to contact me at FixYa.com!

Again my apologies...

ZJ Limited

• 17989 Answers
• Posted on Apr 01, 2010

SOURCE: how to change fuel filter mazada 2003 tribute

Mazda Tribute 2001-06
Fuel Filter - Removal & Installation

1. Before servicing the vehicle, refer to the Precautions section.
2. Properly relieve the fuel system pressure.
   
3. Remove or disconnect the following:
   Negative battery cable Fuel line to the fuel filter
   
4. Loosen the clamp and remove the filter
   

1. Install or connect the following:
   New clips to the fuel lines Fuel filter and tighten the clamp Fuel lines to the fuel filter Negative battery cable
2. Start the vehicle and check for leaks, repair if necessary.

1. Before servicing the vehicle, refer to the Precautions Section.
2. Properly relieve the fuel system pressure.
3. Disconnect the negative battery cable.
   NOTE To deplete the backup power supply energy, disconnect the negative battery cable and wait at least one minute. Be sure to disconnect auxiliary batteries and power supplies, if equipped.
4. Disconnect the fuel line at the fuel filter.
5. Loosen the clamp and remove the filter.

1. Install or connect the following:
   New clips to the fuel lines Fuel filter and tighten the clamp Fuel lines to the fuel filter Negative battery cable
2. Start the engine and check for leaks, repair if necessary.

Robert Veldman

• 373 Answers
• Posted on Aug 29, 2011

SOURCE: How do you change coil packs on a 2002 Mazada

I believe the Mazda V6 is the same as my 2002 Escape and uses individual coil-over-plugs or COPs. Each spark plug has it's own coil.
I've had an engine light twice, and needed to replace coils. I finally replaced them all. They are available at Ford, car parts stores like AutoZone, or I bought my full set of 6 coils on Ebay.
Autozone coils, for example are about $70/coil.
One of the difficulties with replaceing the coils, is that the 3 coils on the "back" of the engine are covered by the intake manifold. The manifold needs to be removed to get to them. You'll need the manifold gasket set, which costs less than $15.
The coils themselves are easy to replace. Unplug the 2 wire connector, unscrew one bolt (using 8mm socket?), and pull the coil up and off the plug.
I recommend replacing all the coils, and also replace the plugs while you're in there. Use OEM plugs; probably Motorcraft. (If the original plugs lasted 100,000+ miles, why would you experiment with something else?)
Here's a picture of one coil: