Where is the onstar vcim located in cadillac srx 2010

SOURCE: 2006 cadillac SRX , V-6

hi all engine sumps have a drain plug and it is the lowest bolt on the bottom if you cannot find yours because there is a lower cover so you cannot see the sump you will find the cover will have a access cover that can be removed if not this would be unusuall to have to remove the engine cover cpmpletly best of luck yates210456

SOURCE: Replacing front turn signal bulb on 2006 Cadillac SRX

wow i feel sorry for you because Cadillac designed this bulb to be a don't get to bulb but OK here's what you do take the bottom cover off or skid plastic panel under neath the front end theirs little plastic clips holding it on just get come dikes and don't cut them but just use it to help pull them out. after you get that off use a flash light and locate your light housing you should see two screws holding the house in i think those screws are 8mm i cant remember remove those two screws and be careful the metal from the bumper cuts you pull the light housing out and remove all the screws around the housing and open the housing up replace the bulb and make sure your contact to the bulbs clean and then reassemble the way you took apart. if you cant get it well then best bet is take it somewhere i know Cadillac charges an arm and a leg so you can go somewhere else.

SOURCE: rear liscese plate bulbs on 05 cadillac srx

First you have to take out the one and only screw in the rear hatch door - it's where the hand pull down is you use to close the hatch.
Then you have to pop all the plastic clips all the way around the plastic door panel, trying not to pull them out from the frame . If you do pull out the white plastic plugs from the frame you better make certain you take them off the plastic housing and insert them back into their frame holes - or you will never get the housing back on.

Once you have the housing loose disconnect the inside tail gate light wire to remove the whole thing. Then you have to remove 7 to 8 nuts from the back of entire License plate, back up bulb housing using a deep socket to get in there. Work it loose from the rear of the car and it will come out just enough to work on the lights.
This is tricky since the screw mounts don't give you much room to work with.

Once you have the license plate and back up bulb frame loose you will see the two housings for the license plate bulbs on top.

Slide out the license plate bulb lens and twist the bulb connection to remove the bulbs.
Replace both of them - you don't want to do this again in a month when the other one blows.

OPTIONAL:
Once you take out the bulbs you might see that the housing is melted where the bulb wanted to burn through. Drill two small holes one is each end of the housing before I put everything back together to release some of the heat.

Reverse the whole process to put everything back together. It's not easy.
Make sure you insert the cables through the opening for the hatch handle or it will kink and not work properly.

The bulbs come in a two pack of cost $4.95 .

SOURCE: 2007 CADILLAC SRX

Recently had the same problem my friend......The O2 Sensor can simply mean that your gas cap is not on tight enough, or possibly your purge solenoid.
I am just a regular average guy, and I am retarded when it comes to cars, so I asked a mechanic on ask.com cadillac, or something like that...anyways......The purge Solenoid only costs about 35 dollars, and is super easy to replace. The hard part is getting your card started again after your battery is hooked back up because of the Cadillac theft detterant system. After you put the Purge Solenoid in, and hook up your battery make sure you do the following to bypass the security system:
1. Turn key in ignition all most all the way on, but don't turnover.
2. Leave in this position for 10 min exactly
3. Turn key back for five seconds
4. Repeat this sequence four addtional times.
5. On the fourth time the car will turnover, and you are good to go.

I hope this helps, cause cadillac almost bent me over on this one....
Dom

SOURCE: Where is Cadillac SRX Battery

Its under a cover under the hood either in the left or right corner