Reset stations on jeep wrangler 1999

Question edited for clarity.
Question moved to make year model category.

All the fuses and their functions are here

Fuse Box Diagram Jeep Wrangler (TJ; 1997-2006)

https://fuse-box.info > jeep > jeep-wrangler-tj-1997-20...
The fuse panel is located behind the glove box. The location of the fuses in the passenger compartment: Jeep Wrangler (TJ; 1997. To access ...

..

sometimes , when a battery goe's down, and you replace them, or jump start them, the computer has to reset itself and it will take a few minutes to do this, but afterwards, it should be fine, if you still have the problem, check for trouble codes.

There is no inertia switch on a 1999 Wrangler.

the brake switch on top back of brake pedal is shorting out.

Check HERE for few engine sizes:
- 1999 JEEP WRANGLER - L4 2.5L 150ci GAS FI N P
- 1999 JEEP WRANGLER - L6 4.0L 242ci GAS FI N S

Hope this help (remember comment and rated this post).

IS YOUR 4X4 ACTUALLY ENGAGING, IF SO THEN THE BULB BEHIND CLUSTER IS MOST LIKELY BURNED OUT

if you are receiving stations on the higher frequencies then your radio is the problem and not your antenna or anything else

my 99 jeep wrangler has the same problem when I had it looked at they told me its a chrysler problem and there is nothing wrong and there is a short under the dash I had them reset the warning light for an emissions test but the light came back on in a few days. It was not worth the expense to try and find the short

reset light and make sure gas cap is secure.

Check the gas, could be water in it or drive the car with a fuel pressure tester connected to it and watch to see if you lose pressure.
Normal pressure while driving is about 30 to 40 psi