Cars & Trucks Logo

Related Topics:

I have a 1990 Chevy C 1500 and I disconnected an aftermarket alarm truck won't start but it was running fine before what the problem could possibly be or if there's a wire I don't have hooked up right

5 Related Answers

Anonymous

  • 4669 Answers
  • Posted on Mar 02, 2009

SOURCE: 98 chevy 1500 4.3L vortec misfire problem

These have a real problem with the distributor caps, i would try that

Ad

Anonymous

  • 3 Answers
  • Posted on Mar 13, 2009

SOURCE: Have a 1992 chevy 1500

try the ecm fuse

Anonymous

  • 206 Answers
  • Posted on Mar 29, 2009

SOURCE: chevy 1500 1999 starts fine but in park/drive at 1500-2000.rpms

Sounds like a fuel pressure regulator is bad

Anonymous

  • 1 Answer
  • Posted on May 15, 2009

SOURCE: Truck won't start something to do with Anti-Theft tried removing positive cqble to reset alarm nothing, possible wire off Anti Theft Unit Truck drove fine parked for one hour and went to leave, the en

not positive but look in owner manual for a fuel pump reset button i had this problem at one time and that fixed it it is usualy under the dash area somewhere on the drivers side or in a kick panel (decorative cover on the side firewalls inside the cab)....good luck i hope this helps!

mythman

Charles Mijares

  • 84 Answers
  • Posted on Jun 30, 2009

SOURCE: new battery -alarm sounds- have to disconnect the battery-

The sounding alarm maybe a security system installed by in the truck. Disconnecting the battery will only temporarily solve your problem, but will resume once you reconnect the battery for electrical power.

You must find the keychain/remote of the security system and disable it. If you are unable to locate this, you can have it disconnected by a qualified automotive electrician.

Word of caution though, if you are using the keyless entry system with the security system, this will be disabled until you install a receiver with such function.

Hope this helps.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How to wire the harnesses back to normal under dash after removing aftermarket alarm now the truck won't crank or start on my 1990 chevy c1500

go back and check the wiring you have removed some wires that you have disconnected ie ign or starter motor need to be reconnected back together check the wiring colors and reconnect back together to complete it back to origional good luck
0helpful
1answer

How to disconnect the alarm in my Chevy 1500 year 2000

factory and aftermarket are two different alarms. if it is aftermarket look under the dash there should be a toggle switch in plain view turn the key on and then flip the switch and turn the key off it will turn off the alarm.
0helpful
1answer

Alarm won't shut off on 1999 Chevy blazer 4x4

Is it factory alarm or aftermarket??. Try using the key to lock and unlock the doors driver and passenger then turn the ingnition on with the key and leave it in the key on engine off position for a few minutes and start the vehicle
0helpful
1answer
0helpful
1answer

The alarm goes off periodically, t he lights flash, door locks start to clickat night the parking lights come on, my battery gets drained and it won't start

Aftermarket alarm failure it the transponder or transducer adjust the sensitivy and it will still give problem your solution is remove the alarm or diable the alarm go under the dash there you will fing the ignition harness where the aftermarket alarm installer has cut and spliced into the ignition to install a relay you will cut it and restore the original condition it simple follow the color of the wire they cut and restore it back if you use a but connection make sure it wont seperate and get you stranded you are better off soldering the connection back and wrap it with electrical tape to protect it from shorting out.
1helpful
3answers

1990 chevy silverado 1500 single cab. 180K miles. Last few days if the truck sits for 8 hours truck has a hard time starting up. Takes a good push on the gas to get running. Oil changes and fuel...

yes sounds like the fuel filter is clogged when push gas pedal put it in clear flood mood and resets the fuel system and starts over thats why it starts when push to floor creates back pressure sucks debri bottom of filter
3helpful
2answers

1990 Chevy Scottsdale 1500 wont idle when first starting cold

ICM idle control module, loc throttle body, it may be dirty, remove clean or replace, its easy..
0helpful
2answers

1990 acura integra.

check the wiring under the dash see if there is aftermarket alarm wiring spliced into the wires from the ignition switch to the fuse box. You may have knocked one loose while you were changing the relay.
Not finding what you are looking for?

104 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...