Question about Mitsubishi Montero Sport

Open Question

Where is the crankshaft position sensor in a Mitsubishi Montero sport located?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
Technopro
  • 243 Answers

SOURCE: Car Problems

can you give us your engine number?

Posted on Oct 27, 2008

Ad
leetamara
  • 702 Answers

SOURCE: where is the crankshaft position

near the harmonic balancer.

Posted on Nov 09, 2008

Big Poppa Ma
  • 302 Answers

SOURCE: 2002 Eclipse

its by your intake manifold on the bottom of the engine block. there is a heat shield covering it which will need to be removed to get to it

Posted on Dec 06, 2008

DSMprostyle
  • 37 Answers

SOURCE: crankshaft position sensor location

Hello. One way to check if it is working is when you try to start the car does the needle move on you tac? If not then your crank sensor is more then likely the problem. It is located on the backside of the engine under the intake manifold. If is in about the center of the block. There will be a 10mm bolt holding the sensor in. If you decide to change it yourself (not to terrible of a job) unplug the sensor, remove the bolt and spin it back and forth slightly while pulling it out. It may be stoburn and you might have to work at it for a little bit (not a done of room) but it will come. When it's out the sensor will be shaped kind of like an L. I have changed a few of these over time and they can be a little stoburn. To install just reverse the process.

Posted on Mar 26, 2009

polarcycle
  • 1392 Answers

SOURCE: 2004 DODGE STRATUS 2.7L, Location of Crankshaft Position Sensor?

it is located on the right side of the motor, in the trans area. Actually in the bell housing.

Posted on Jun 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 Mitsubishi montero sport xls replaced crankshaft sensor still will not crank


Test fuel pressure at key on. Next test for spark to plugs. Use "noid" light to test for injector pulse.

Jul 03, 2016 | 2001 Mitsubishi Montero

1 Answer

Where is the crankshaft position sensor located on the 2002 Mitsubishi Montero sport xls 3.5 truck.


Hi David, The link below is how to test the crank sensor (1997-2004 3.0l Montero, Hope this helps......CHEERS
http://easyautodiagnostics.com/mitsubishi/3.0L/crankshaft-position-sensor-test-1#3
The crankshaft position (CKP) sensor is located behind the timing belt... but testing it is done without removing the timing belt or its components. This is due to the fact that the crank sensor's connector is located on top of the engine and in plain view (next to the ignition control module). In the photo below, the orange arrow points to the location of the crankshaft position sensor connectors (photo applies to: 3.0L 1997-2004 Montero Sport).

Mar 31, 2016 | Mitsubishi Cars & Trucks

1 Answer

Where is the crank sensor located on 1999 montero sport


Crankshaft position sensor A (24x) is behind the crankshaft pulley.

Crankshaft position sensor B (7x) is on the lower back side of the engine block.

May 12, 2014 | 1999 Mitsubishi Montero Sport

2 Answers

Where a part is


LOOK ON LOWER SIDE OF CYLINDER BLOCK.

Jul 04, 2010 | 1997 Mitsubishi Montero Sport

2 Answers

Where is the timing mark in the crankshaft of a 2000 montero sport


Click on the following free direct Link. It has the Timing: Belt and Mark Diagrams for your 2000 Mitsubishi Montero Sport. Plus additional Instructional and Directional Diagrams.

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

http://www.2carpros.com/car_repair_information/year/2000/make/mitsubishi/model/montero_sport/2000_mitsubishi_montero_sport_timing_belt_diagram_marks.htm

Dec 13, 2009 | 2000 Mitsubishi Montero Sport

1 Answer

1999 Mitsuishi Montero sport 2H shift light flashing


Bad 4wd position sensor located on transfer case or bad sensor located on right front axle housing for 4wd engagement position.

Mar 29, 2009 | 1999 Mitsubishi Montero Sport

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

277 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

Marvin
Marvin

Level 3 Expert

85160 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...