Where is the horn relay located on a 2004 Chrysler Sebring? There's nothing that says horn relay.

Harry Goodwin

• 353 Answers
• Posted on May 14, 2009

SOURCE: where is the starter located on the 2004 chrysler

look around the bottom of the motor at the rear of the block on both sides. it should have a thick battery cable attached to it and a couple of smaller wires attached to it, one on the solenoid and one one the same terminal as the thick battery cable
hope this helps you

SOURCE: Where is the crankshaft position sensor located?

the crankshaft position senor on the 2.2L is located on the rear right side of the engine block

SOURCE: I can't locate the fuel filter on my 2004 chrysler

I would check if it is in the gas tank on that model. you can go to your local parts store and they should be able to inform you of this.

SOURCE: oil sending unit on 2004 chrysler sebring V6

Should be located close to the oil filter. It will screw in like a spark plug. It has a harness plug. Easy to change, save yourself $70 in labor. You will need a fairly large wrench to remove

SOURCE: Where is the fuel filter located on a 2004 Chrysler Sebring Sedan

Some of the Sebrings have two filters(one is called a sock).The sock(which all sebrings have) is located in the fuel tank itself on the pump module.If this model is the JXI then the external filter is located on the belly of the car between the tank and drivers rear seat. I hope I could help!!!