SOURCE: fuel filter replacement
the fuel filter is located on the drivers side under neath where the rear seat would be connected to the frame. relieve fuel system pressure,disconnect negative terminal from the battery,raise rear of vehicleand support it securily on jackstands,detach fuel lines from the filter,some have quick connect . squeeze plastic tabs to pull the connector apart,if it has threaded fiting unscrew the fuel line from the filter.
SOURCE: 2000 Chevrolet Malibu LS airbag problems
The passenger side airbag is a lot easier then driver side. Take the glove box out and you will see two 10mm bolts holding it in place. When you open the passenger side front door, remove the panel on the side of the dash and you will see yellow connectors.The 1 closest to the front is attached to the air bag, it is clipped into the frame. Just pull it loose and take it out and your done. For the Driver side, it takes a skinny T27 to remove the two star bolts, then just disconnect the horn red clip and ground and install new airbag. The module is located under the passenger seat, underneath the carpet. Kinda stupid but thats where its at. You also need to replace the front impact sensor located behind the grille on the back side of the metal bar to each side. Follow the hood latch down. Also just to make sure, you know to disconnect the battery before you do all this. You don't want new airbags to accidentally deploy.
SOURCE: battery removal 2000 cadillac deville
Its on passenger side under rear seat cushion. Get in back seat FACING rear seatback, grab under lip of bottom seat cushion, and pull straight up. Disconnect seat heater connector (if so equipped) on passenger side and remove seat bottom. Tada! There ya go! Oh... btw. Its a $150 battery due to the venting system designed into it to vent fumes through a tube to the outside world. Thanks Cadillac!!! :(
SOURCE: 2000 cadillac deville remove door panel
2000-2001 Deville Door Panel
Removal:
1. Position window
fully downward and ensure manual lock knob is in unlock position.
2. Disconnect
locking clip at front of manual lock knob, by insertingsuitable flat
bladed tool into top service notch.
3. Remove manual
lock knob.
4. Remove inside
handle bezel by holding inside handle to open position, inserting
sutiable flat-bladed tool at front lower corner and prying outward.
5. Remove bezel.
6. Remove inside
door handle mounting screw.
7. Disconnect
eight retainers around outside edges of door trim panel using clip zip
tool No. J-36796, or equivalent.
8. Slide door trim
panel upwards to release alignment datums, eight retainers, armrest
steel retainer clips and inner belt mouldings (see fig #7 amd #8).
9. Disconnect
electrical connector(s).
10. Reverse
procedure to install.
Hope this help (remember rated this).
SOURCE: how to remove front and
go to auto parts store or retail store to get a tool called panel popper. it has 2 prongs shaped like a wrench on a shaft (like a screw driver). check panel for screws to remove and after remove screws, use panel popper to pry the panel up. put the panel popper near the plastic tabs that hold the door in place.
Whenever this warning or any other stays on in the dash it is indicating that the systems control module has detected a fault, it then disables the system as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)
1,114 views
Usually answered in minutes!
×