Replacing license plate bulb 2008 Honda Odyssey how do I replace the bulb

License plate lights

You might be able to access it if you stick your hand up inside the rear of the bumper.

most likely the bulb, they are fused with the parking lights, if ur parking lights work most likely the bulb good luck

Duplicate question.

Watch the video bellow, theres a guide step by step. Also the bulb can be found on Aliexpress Homepage
It's the biggest and cheapest worldwide suplier.
Just type the correct name into the searchbox and
thats it
wish you luck

The license plate lights are accessed by unscrewing the lens. The backup lightbulbs are accessed with the trunk lid open, behind the cover.

go to license plate look above it and you will see the globe or globes remove cover and replace bulb,can get at garage

You should have two license plate lights, right above the license plate. If you remove the two screws that hold the one you want to change in, the entire fixture will drop down(best to do this with the trunk open). Remove the metal clip plate that covers the bulb. The bulb SHOULD simply pull directly out.
Hope this helps you.

send for one here in the USA ..or ...find a possible close fitting of a different origin make one and with a bit of doing convert it over

Hi,
Their is a plastic lens covering the licence plate bulb. I can be removed by using a flat-tipped screwdriver covered by a shop towel (or tape) on the right side of the lens. It should pop off where you can access the bulb.
Good Luck!