What is the cylinder number location for olds 4.0

The location of the number 1 cylinder in a 2008 Hyundai Tucson is determined by the engine type and layout.
Hyundai Tucson 2008 models comes with 2 different engine types :

• 2.0L I4 engine
• 2.7L V6 engine

In both engines, the firing order is 1-3-4-2, and the cylinder layout is inline or straight.
The cylinder layout of the 2008 Hyundai Tucson with 2.0L I4 engine is inline 4-cylinder, meaning that the cylinders are arranged in a line, one after the other. In this configuration, the number 1 cylinder is typically located at the front of the engine, on the driver's side.
The cylinder layout of the 2008 Hyundai Tucson with 2.7L V6 engine is V6 engine, meaning that the cylinders are arranged in a "V" shape. In this configuration, the number 1 cylinder is typically located at the front of the engine, on the driver's side, and it's the first cylinder on the left bank.

STANDING FRONT OF VECHICLE CYLINDERS FACING YOU ARE 4 5 6 AND BACK CYLINDERS IS 1 2 3 NOW ON PIECE PAPER LOOKING AT IGNITION COIL PACK FACING YOU WRITE BACK NUMBERS 123 AND UNDER THAT NUMBER 1 2 3 WRITE FRONT NUMBERS 5 6 4 THATS YOUR COIL PACK PLUG WIRES LOCATION. LIKE I SAY 5 6 4 IS PLUGS WIRES LOCATION FACING YOU AND BACK NUMBERS 1 2 3 PLUG WIRES LOCATION ON COIL PACK. FIRING ORDER IS 1 4 2 5 3 6

STANDING IN FRONT OF CAR.CYLINDERS FACING YOU FROM LEFT TO RIGHT IS 1 2 3 THIS INFORMATION I GAVE YOU FOR THE 3 CYLINDER 993 CC ENGINE. DRAW A CIRCLE ON PAPER WRITE DOWN THE NUMBER 3 ON TOP OF CIRCLE AND NUMBER 1 AND 2 UNDER THREE THATS YOUR DISTRIBUTOR WIRE LOCATION.NOW IF YOU HAVE THE 1295CC 4 CYLINDER ENGINE.STANDING IN FRONT OF CAR CYLINDERS FACING YOU LEFT TO RIGHT IS CYLINDERS 1 2 3 4 DRAW CIRCLE ON PAPER WRITE NUMBER 4 TOP OF CIRCLE WRITE NUMBER 1 BOTTOM OF CIRCLE.ON LEFT CIRCLE WRITE NUMBER 2 AND FROM RIGHT OF CIRCLE WRITE NUMBER 3 THATS ALL SPARK PLUG WIRES LOCATION ON DISTRIBUTOR WHILE STANDING FACING THE FRONT OF THE ENGINE.

Hello jewel4340,

Below is a depiction of a 5.4 with the cylinders numbered. Number 4 cylinder 4 is the furthest to the rear on the right hand side ( passenger side)



Regards,
netvan

1-5-3-6-2-4 I'm going to completely assume that the GMC envoy, based on what I can gather, uses the old 235 Chevy (50's) design, since it reduced balance issues, and therefore, this would be the right sequence.

1-8-4-3-6-5-7-2 is the firing order, The Number 1 cylinder is normally marked on the cap with raised dot or something similar. What specific problem are you having?

For the 2002 Santa Fe 2.7L V6:

Firing Order:
1-2-3-4-5-6

Cylinders:
....(back)
1.....3.....5
2.....4.....6
....(front)

Ignition Connections:
(back)
o <---3
o <---6
o <---2
o <---5
o <---4
o <---1
(front)

To be 100% sure it is 1-2-3-4-5-6. Your number one Cylinder is located on the backside of the engine (closest to the windshield) on the Passenger (aka right) side of the engine. Number two is located on the front of the enging (closest to the bumper)farthest right (passenger side). So the cylinder numbers on the back of the engine are 1-3-5 and the cylinders on the front of the vehicle are 2-4-6.

You didn't specify whether you have the (4) cylinder or the (6) cylinder engine..... I have a 2004 Hyundai Sonata 2.4L 4 cylinder and I just changed the spark plugs in it. I believe that the 2005 2.4L engine is the same. To locate and change the (4) spark plugs on a 2004 Hyundai 2.4L 4 cylinder engine: Remove the (4) 12mm bolts from the decorative plastic engine cover. Remove plastic cover from engine and place it off to the side out of your way. Standing in front of the car, the (4) spark plugs are located laterally (left to right) in the recessed area underneath where the plastic engine cover was removed. Note: This engine has (2) coils....They are located above spark plugs number (2) and (3) from left to right. Starting with the fist spark plug on the left: Remove the spark plug cable by pulling straight up on the insulated connector. Using a spark plug socket, remove the old spark plug and install a new one in it's place. To access the second spark plug from the left, remove the electrical connector and the spark plug cable wire from coil number (1) and then remove the (2) 12mm bolts that secure the coil to the engine. Spark plug number (2) is located directly under the coil. Lift the coil straight up removing the insulated connector from spark plug number (2). Using a spark plug socket, remove old spark and install a new one in it's place. Repeat same procedures for spark plugs number (3) and (4). Note: If you have the (6) cylinder engine, the front (3) sparks pluge are readilly accessible but in order to access the (3) rear spark plugs, you will have to remove the intake manifold

To locate and change the (4) spark plugs on a 2004 Hyundai 2.4L 4 cylinder engine:
Remove the (4) 12mm bolts from the decorative plastic engine cover. Remove plastic cover from engine and place it off to the side out of your way.
Standing in front of the car, the (4) spark plugs are located laterally (left to right) in the recessed area underneath where the plastic engine cover was removed.
Note: This engine has (2) coils....They are located above spark plugs number (2) and (3) from left to right.
Starting with the fist spark plug on the left: Remove the spark plug cable by pulling straight up on the insulated connector. Using a spark plug socket, remove the old spark plug and install a new one in it's place.
To access the second spark plug from the left, remove the electrical connector and the spark plug cable wire from coil number (1) and then remove the (2) 12mm bolts that secure the coil to the engine. Spark plug number (2) is located directly under the coil. Lift the coil straight up removing the insulated connector from spark plug number (2). Using a spark plug socket, remove old spark and install a new one in it's place.
Repeat same procedures for spark plugs number (3) and (4).
Note: If you have the (6) cylinder engine, the front (3) sparks pluge are readilly accessible but in order to access the (3) rear spark plugs, you will have to remove the intake manifold.


please rate!