Follow the link Torque Specs Database
SOURCE: thermostat in a 1997 hyundai elantra
See exploded view
REMOVAL
1.
Drain the coolant down to thermostat level or below.
2.
Remove the coolant outlet fitting and gasket.
3.
Remove the thermostat
SOURCE: hyundai elantra 1.6GLS J2 torque settings
dear friend:here follows the settings in need:
cylinder head-30-35 nm + 30-35 + 65deg + 65deg.
mains-30nm +65deg
big ends- 1 - 26nm 2 - 52NM
fly-wheel -130nm
cam-sprocket - 100-120
crank-pulley - 170-180
cam caps -15nm
SOURCE: i have a hyundai elantra 1.8gls could you assist
dear friend-please find the settings you are looking for below:
mains 30nm * 65 deg
big-ends 26nm * 52nm
cyl head 35nm * 65deg *65deg
flywheel 130nm
oil pump 15nm
crank pulley 180nm
SOURCE: need cylinder head torque specifications 2004
Install the cylinder head bolts. Starting at top center, tighten all
cylinder head bolts in sequence as shown in illustration, using the
Cylinder Head Bolt Wrench (09221 - 32001) or equivalent. Repeat the
procedure, re-tightening all cylinder head bolt to the specified torque.
(torque spec is Cold Engine 105-115 Nm (76-83 ft lb) )
. Install the timing belt tensioner pulley.
. Install the timing belt on the camshaft sprocket, making sure that
the tension side is tightened by turning the camshaft sprocket in
reverse, all timing marks are in alignment.
. Adjust the timing according to "Timing Belt"
. Install the rocker cover and tighten the bolts to the specified torque. Tightening torque: Rocker cover belt:
2.5-3.5 Nm (25-35 kg.cm, 2-3 ft. lbs.)
. Install the timing belt cover.
Install the new intake manifold gasket and the intake manifold. Tighten the nuts and bolts to the specified torque.
Install the new exhaust manifold gasket and the exhaust manifold.
Tighten the exhaust manifold attaching nuts to the specified torque.
. Install the surge tank and tighten the nuts bolts to the specified torque.
. Install the power steering oil pump and bracket.
. Install the ignition coil.
. Install the air intake hose.
Connect the vacuum hose, fuel hose and water hose.
. Install breather hose.
1,062 views
Usually answered in minutes!
×