This is most likely just the rubber stop needs adjustment. Try unscrewing the one on the stuck side by half a turn.
The stops are like black cotton reels and are threaded.
GOING TO NEED TO REMOVE THE DOOR PANEL AND INSPECT LINKAGE. PROBLY PLASTIC CLIP BROKEN
SOURCE: bonnet release
look at it,scratch bum and light a *** puff on same whilst you survey situation.Then go down cafe for coffee .come back and get a big screwdriver and grovel under engine compartment removing belly plate.Find the torch ??then do into town for new batterys and another coffee ,come back talk to another customer for half hour then lay under car and shine torch up and flick lever back so bonnet opens and remove the spanner you left under bonnet last time .Refit belly plate take car for a test drive and go to cafe again for a pincho of tortilla and another coffee.charge customer for a days work.
SOURCE: Driver side Hatch will not release. Passenger side opens.
At the center of the rear door is a actuator that has rods that go to both side and the clip felloff/broke on the Driver(left)side if it has a handel on the inside if you take that apart you can then pull the inside skin back far enough to pull the rod with a pliers and open the door and then make the repairs
SOURCE: Passenger side hood will not release
Hood latch on passenger side needs adjusting, Have someone put pressure on side of hood when
you are pushing the hood latch release.
This may help them when they are pulling up on the hood.
SOURCE: hood (bonnet) latch is not releasing on passenger
sounds like you have a broken cable. Go to the front and using a screwdriver release the catch through the grill.
SOURCE: The pass. side bonnet catch will not release and open the bonnet.
Have someone lift on the bonnet while you pull the release handle.
2,146 views
Usually answered in minutes!
×