How do you get sunscreen panel out of a factory sunroof on 1995 Oldsmobile Cutlass Supreme?!

SOURCE: Replacing a master cylinder in a 1995 Oldsmobile Cutlass Supreme.

Never Never Do this! Just buy a brand new one there is too much at risk sorry never play with brakes just for money. No rebuilt either only bran new will do.

SOURCE: 1995 cutlass supreme transmission

It physically will fit and bolt up,but there are many different ratio,and drive and driven sprocket tooth counts,different final drive ratios,all monitored by the computer with electronic speed sensors.If the trans from the 95 has a different ratio than the 93,the computer will set gear ratio error codes,and possibly put the trans in a failsafe mode,stuck in 2nd or 3rd gear.On the transmission case,down by where the passenger side axle would go in,is a thin metallic tag,maybe 2"x 3",and it has bar codes,and also a series of numbers and letters.The numbers and letters,large cap,are the final drive gear ratio code.They should match on the two transmissions in question.

SOURCE: 1998 Oldsmobile Cutlass Supreme Blower Motor

It's not to hard to do, just have to lay upside down in your pas. floorboard, remove plastic panels under gloove box with small nut drivers,(can't remember size) then there are three hex head screws holding on the blowerplus the wireing connector, anf it has a wierd rubber gasket, hope this helps.

SOURCE: 2000 oldsmobile alero gl 2.4

The window regulator is what causes the plastic clip to break. I had the same problem. I was able to find a new clip at advanve auto parts, and had to purchase a regulator which includes the motor from ebay. There were many diffrent options out there. Total cost was about $60.

SOURCE: 1986 Oldsmobile Cutlass Supreme vacuum hose

Ok sent you this the engine you have to specify that engine has to help you. Thanks

Testimonial: "good job getting info. and real quick too"