Replace 2002 chevy avalanch z71 transfer case

SOURCE: 1999 Chevy 4x4 engaging

Check the solenoid at the front axel. This is a rather common prob. First check that power is at the axel, got power, clean and put it back. Please do not even look at the tranfer case! At worst you may need to replace the axel solenoid! Frankster016

SOURCE: 2002 chevy blazer fuel pump (4 door)

yes you have to drop the tank. you will also need a fuel line tool to unhook the fuel lines. before you drop the tank see if tou can reach and wiggle the electrical connection on the top of the tank. these pumps have a pigtail issue. please rate

SOURCE: 4 wheel drive on 1999 chevy blazer

99 chev blazer should have an electric motor not a vac switch...Is your controll on the dash a switch you turn.. or on the floor you shift ??

SOURCE: 99 Silverado 4-wheel drive not engaging

It does not seem that sufficient diagnosis was done. No, you cant give a specific diagnosis like that without tearing unit down. It's likely that they told you the most common failure and left it at that. Likely there is a problem with your unit...I think this becomes more of a trust issue than a mechanical one. A second opinion from an independent reputable shop may help but either way, you need to have it fixed. In not using it much, it makes me wonder how it got worn.
good luck

SOURCE: stuck in 4 wheel drive and wont come out.

hey there i cant tell you what you are missing but i can tell you how to disengage the front wheels . ok you have a vacum line that runs right under the battery and a line that comes up from the front diff. to the same place ( you may have to remove batt and batt tray to get full access to this) un bolt it and temporaly put batt and batt tray back in start it up and decompress this and see if it comes out .... you should here clunking noise if it goes back in ... if thats the case just pull that big vaccum line off .... to test get all four tires off the ground and have some one put it in drive but dont hit the gas it should turn on its own ...if that dont work check the cable that runs down to the differental