2010 Chevrolet Impala Logo

Related Topics:

Kirk Anderson Posted on Jan 10, 2017

How to go about fixing my accessory plugs in a 2010 chevy impala.

While driving in a bad snow storm my engine light came on. got home and found i had no power to accessory plugs 3of them and my trunk would not open, i can hear it click at the fuse box passanger side but wont open . and there is no key. i have checked codes and relaced fuel cap nd evap canaster by the fill hose under car still got engine light and code ays its electrical .

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Oct 14, 2008

SOURCE: 1996 Chevy Blazer check engine light on

More then likely its the Canister Purge Solenoid. you can find it online at www.autozone.com the part number is PV140. And to replace it on blazer you have to remove the spare tire. Alot of people don't know where this part is so I hope this helps you and good luck.

Ad

Anonymous

  • 4 Answers
  • Posted on Nov 07, 2008

SOURCE: 2002 monte carlo EVAP problem continues.

did you try a vent solenoid? this is located behind left rear wheel in fender.

Anonymous

  • 28 Answers
  • Posted on Dec 07, 2008

SOURCE: obd code po 440

http://www.obd-codes.com/p0440 you may find the answer here or at least what to check. It sounds like the code is intermittent which probably means something is going out just has not yet. My guess is you may have a leak in a hose( maybe a split or crack in hose)

GM Elec

Bruce Bracey

  • 1000 Answers
  • Posted on Feb 21, 2009

SOURCE: My 2001 Chevy Impala won't start,and engine won't

First things first. Do you have a volt meter to check the battery voltage? What engine do you have?
Let me know.
Regards,

Anonymous

  • 1 Answer
  • Posted on Mar 25, 2009

SOURCE: 2001 Chevy Impala won't start

If the battery has gone dead, it could cause the security system to go into full lock-up mode. If it has locked up the accessories will work after the battery is charged back up , but the power to the starter will be cut off and it wont turn over. You need to do the 30 minute learn procedure. A GM dealer will print it out for you and you can do it yourself. It's very simple if you follow the procedure exact. hope this helps and good luck.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

12v accessory plugs dont work in a 2010 impala

Hello Kirk Anderson...

I'm having difficulty relating your "SNOW-STORM"
to your issues... (but I'm old & easily confused)...

Notwithstanding my devotion to factory or
PROFESSIONAL grade workshop (paper) manuals
there are some excellent FREE cyber-sites

One such... (registration is required (but painless))
For popular AMERICAN market vehicles...
FREE drawings & TSB (Technical Service Bulletins)
are also available at BBB Industries site...

BBB Industries Premium Alternators Starters Power Steering Products
1helpful
1answer

How do I diagnose and fix a P0449 code in a 2010 Chevy Impala? Also, is it safe to actually drive the vehicle with this code?

Evap Emission Ctrl Sys Vent Valve/Solenoid CircError. Depending on where you are your car might fail MoT test but you can drive with decreased fuel efficiency though.
0helpful
1answer

My 01 chevy impala keep using up to much gas .what

Run a diagnostic to see if you've any bad sensors in the system. If none are found and your check engine light is on, then it's a mechanical problem. Like possibly a bad seal on the gas cap. Little things like that can cause bad fuel economy.
0helpful
1answer

Subaru rolling over, but won't fire

the mistake is washing the engine bay
water gets into every electronic connections and shorts out everything
use compressed air in all of the harness connections and use dewatering fluid ( wd-40 or the like )to remove the water
0helpful
1answer
0helpful
1answer

Troubleshooting code po411 2010 Chevy impala

secondary air injection incorrect flow
with out being able to hook up a scanner and see live engine data
the most common cause that i have seen is a bad solenoid sensor and a bad check valve in the secondary air pump
3helpful
2answers

2006 Chevy Impala, engine light is blinking and seems like no gas is getting to the engine and stalls when I'm not stepping on the gas

any time the check engine light is flashing the engine is miss firing, most likly cause is spark plug wires or colis, but also check the wiring harness from the crankshaft sensor to the ignation module they have a bad problem with coming out of the wiring lume and geting melted on the rear exhust manafold...good luck
1helpful
2answers

Have a 2001 chevy impala runs great on acceleration but rough on idle engine light is on gas milage is down replaced plugs and wires wondering if i have an issue with the oxygen sensor

your check engine light will give you information that will help solve the problem-get the computer scanned, go to a retail auto parts store, they all do it for nothing. Write down the actual codes, and come back here with the codes, you will get the help you need.
4helpful
2answers

We are in a 2011 chevy impala...it says service stabilitrak?

If this is a 2011 Early issue, a vehicle made after Sept 2010, or a 2010 for that matter it is under warranty. Take it back to the dealer and make them fix it. The reason I say this is that 1. The repair should be free and 2. There may be a recall on a part that is causing this to come up and again it would be free to be repaired.
Not finding what you are looking for?

168 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...