1991 Mitsubishi Might Max Timing Belt

Mitsubishi Mighty Max crankshaft bolt Questions & Answers ...

www.fixya.com > ... > crankshaft bolt > Cars & Trucks > Mitsubishi

Mitsubishi Mighty Max cars & trucks crankshaft bolt questions and answers. ...Torque specs for mighty max The head torque specs for 1991 mitsubishi mighty max 2.4 I ... 1989 mitsubishi 2.0 motor crankshaft was turned while timeing belt was off. ...how to install a clutch kit on my 1994 mitsubishi mighty max Disconnect the .

The problem may be a cam/crank position sensor that is causing this. Check that the cam shaft is turning ( broken timing belt/chain)

if it's not on the sticker under the hood then look in a Chiltons manual for your truck.

necesito la imagen de la bobina de ignicion

the basic rule about timing belts,first line all dots upon the front of the gears is a indent/dot line that with the indent/dot on the backing plate it also has a dot/indent line all up and place belt on and make sure you dont move anything when you tighten the belt.did the engine suffer much damage when the last belt broke??????adrian,,,,

if it has a cable for clutch you need to adjust it. if its hydralic then the master cylinder may be not bleeding off properly when cold or slave sticks when cold. you need to measure pedal free play that is how far pedal goes down before resistance is felt there needs to be 1/2 to 1 inch or so free play to make sure that the release bearing isnt riding on the pressure plate [would be the same as riding the clutch] the 1/2 inch higher than brake pedal probem can be adjusted on the pedal stop but shouldnt be the problem. of course the clutch could be just plain worn out to.

Sorry for the severe delay.
I am personally going back to answer your unanswered question.
I do not know if you still need the answer, but I am going to answer it in case you still do.

Click on the following direct Link. It has the Timing Belt Diagrams that you will need. Plus additional Instruction and Directional Diagrams you should use.
Again my apologies...
Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!
http://www.2carpros.com/car_repair_information/year/1988/make/mitsubishi/model/pickup/1988_mitsubishi_pickup_timing_belt_diagram_marks.htm

Per my Chilton's manual tehe bolts should be (cold engine) 65 to 72 FT. Pnds., the cam shaft bearing bolts should be 8x25 = 15 - 19 Ft pnds and the 8x65 should be 14 - 15 Ft Pnds.

The sequence is as follows for the (10 ) head bolts:

7 - 5 - 2 - 4 - 10

9 - 3 - 1 - 6 - 8

I hope this may help,
Tom

Engines backfire when timing has slipped. You might need a new timing belt. \

Timing belt goes from Crankshaft on bottom of engine to Camshaft on top of engine. Both have to be synchronized to the correct timing.

Check repair manual or internet for correct timing. You'll probably have to find top dead center on first piston.