SOURCE: 2006 town and country passanger sliding door problem
I've leased two Town and Country vans over the past 4 years, and actually purchased the latest one after the lease. In both vans the sliding doors, normally the drivers side, reacted teh same way. If the door was closed it would open, stop a one point, and then return to the open position. At times I could get it close. But over time the doors stoped working all together.
It is not due to the switch or the motor. Most cases like this (in in both of mine) it is due to the repetitive use of that door, and the realitive inflexibility of the wire harness. Over time, and with more uses (in my case the driver side sliding door was used alot) the wire in the harness fails. Picture it as a willow branch. One snapped off of a tree it first is green and flexible, and bends pretty well into any form. But over time, with age and repetitive bending, it will break.
The only recourse is a new harness, as the wire/wires are broken somewhere in the harness (the belt chain in the lower track of the door). I was temped to take it apart and try to repair it myself, but as the parts were under warranty (I have the extended 85,000 mile), I opted to have the professionals handle it. The repair without the warranty is under $200 typically (parts and labor). Good luck.
SOURCE: i have a problem with power sliding doors on 2001 Chrysler Town and Country limited
do you mean they are sticking?
SOURCE: The power lock (driver's side sliding door) on our
Take a look at end of door where latch is & post where the 2 meet when closed. Look for round metal button/contacts, about 1/2" in diameter. If you look close, they should line up to make contact with each other when door is closed. Take some fine steel wool (preferred) or fine sandpaper and scuff them up until you see metal is clean on both surfaces. Now try it, and let me know what happens.
SOURCE: Power door lock inoperable on passenger sliding door only
Not sure if they are same on 2006 but there should be a couple of small rounded metal contacts, or similar, on door that meet with door post to complete the connection. When you find them, clean them off with a little fine steel wool or SOS pad, minus the soap, and see if that doesn't cure it.
SOURCE: power sliding door will not activate
oh we have a 02 C T & C and our keyless entry for the sliding doors. when the side doors are not closed all the way or opened all the way the keyless entry won't kick in. try doing it closed or fully open, if this does not work try checking the battery in the remote. over all lets put it this way the 02 C T & C is like the best mini van around however it comes with alot of problems from ac. to tail lights
159 views
Usually answered in minutes!
×