Did the light come on after bleeding?????????
or light on now and you want to bleed for some reasons.
the lamp on means 1 thing. (stuck on)
scan THE ABS.
did you? if not you will spend a fortune guessing, sorry....
the bleed procedure is only special if you opened the system in font of the ABS modulator.
can be special.
my jeep needs a special ABS tool to bleed the ABS
the book on this car, i just looked says.
why not tell if system was breached first.?
why make every one guess the history, !
tell the full story and magic happens, (no more lies , no more wild guessing on things that did not happen), yah!
The ABS brake system is bled in the usual fashion with no special procedures required. Refer to the bleeding procedure located earlier in this section. Make certain the master cylinder reservoir is filled before the bleeding is begun and check the level frequently.
you only need the ABS scanner to scan it.
the tool is not needed to bleed, like all JEEPS need. this is no jeep.
well, its a Japanese jeep sure.
why not answer line one above./???
×
The abs light on means that there is an abs fault which could be any of the following
speed sensor on a wheel faulty
sensor ring teeth missing
cracked wire corroded connection
abs controller or pump failing self test
leaking brake pipes or brake pistons
was the brake master cylinder reservoir low to empty of fluid before the light came on
what code did you get when you read the abs fault as it may not be fluid related and bleeding the brakes will not clear the fault
Testimonial: "I will check on them all."
why not answer the when did the lamp come on.
1: before the bleed, or service, or opening up lines.
2:or after.
is this hard? It IS KEY TO THE ANSWERS ,to be correct.
we have no idea what you did. at all.
×
You need a special tool to do this.
779 views
Usually answered in minutes!
×