How do I get the ABS/VDC/AWD lights off on my 2008 Nissan Rouge not that I have replaced my left ABS Wheel speed sensor?

Damaged wheel speed sensor or speed sensor wiring harness. First get the trouble code read tho. That's ALWAYs the starting point. An ABS code will prevent traction and stability systems from working.

Abs light usually caused by bad wheel speed sensor.
If cruise works but light is not on, replace bulb in cluster.

It could imply that the sensor is shifted or defective.

Have the ABS codes read. Could be a speed sensor at the wheel.

Vehicle Dynamic Control, measures inputs from different sensors ie: wheel speed from ABS wheel sensors, trans gear position & speed, Yaw rate, throttle position, etc then makes determination on how to best control veh in a certain situation (accelerating to hard through a turn, wheel spin on wet pavement, sliding during hard stops and such). Can do one or a combination of commands to recover an out of control veh like release brake psi to locked wheel (ABS), limit accelerator, down shift trans, even transfer shift power from side to side/frt to back on some models.

Since you replaced the pick up units or sensors, check the tone rings on the axle shafts. The tone rings is what the sensors detect and are located at each wheel that has ABS. A tone ring looks like this:


This tone ring is on a Ford Ranger - which is pretty much the same as your Mointaineer. Notice the break in the tone ring. This will cause an ABS Fault indicator and will need to be replaced to extinguish the lamp. Check the brake fluid level and top off if needed.


Try another AutoZone or similiar to get a code and be non-specific about the light - just say a light came on on the dash and you don't know what it is about.

Good luck!

CODE P1574 - ASCD VECHICLE SPEED SENSOR. POSSIBLE CAUSES, HARNESS OR CONNECTORS CAN COMMUNICATION LINE IS OPEN OR SHORTED. UNIFIED METER AND AC AMP. VDC TCS ABS CONTROL UNIT WITH VDC MODELS. ABS ACTUATOR AND ELECTRIC UNIT CONTROL UNIT WITHOUT VDC MODELS. FAULTY WHEEL SENSOR. TCM AT MODELS. ECM FAILED.

After a while the light will go off. but autozone should have cleared it for you. If you bought the part through them.

CHECK ABS FUSE AND RELAY.THE AWD CONTROLED BY SPEED SENSORS ONE IN THE FRONT OUT PUT SHAFT SECOND SPEED SENSOR IN THE REAR OUT PUT SHAFT THIRD SPEED SENSOR IS VECHICLE SPEED SENSOR.BEST TO HAVE VECHICLE FIX AT A GARAGE OR DEALERSHIP YOU WILL NEED DIAGNOSTIC EQUIPMENT TO WORK ON IT.

VDC/ OFF light is still ON only ? or also SLIP + VDC/OFF ?

if VDC/OFF only u must check ur brake fluid status if both VDC and SLIP u still have problems with ur ABS module and steering wheel