2007 Toyota RAV4 Logo

Related Topics:

g
g j koorts Posted on Dec 19, 2016

2007 Rav 4 diesel coolent lose in resevior top waterhose warm bottom much cooler presure building up in bottle I suspect thremostat fault can you please advise me

5 Related Answers

Anonymous

  • 74 Answers
  • Posted on May 23, 2009

SOURCE: audio system on 2007 Rav 4

if it doesn't have an aux jack, you will have to get an adapter that plugs into your cigarette lighter/ power source plug. then you can tune to 88.7fm(unless a different channel is specified)

Ad

Greg Mills

  • 497 Answers
  • Posted on Aug 22, 2009

SOURCE: coolent lose

Check youre waterpump...also spending 5 dollars on "Radiator STOP Leak" is a good investment. its an additive you add to youre radiator. If the actual radiator has a small crack or leak, this will fix it. Check every inch of both the upper and lower radiator hoses and connections.

mongos child

  • 5 Answers
  • Posted on Sep 22, 2009

SOURCE: replace rear wiper 2007 RAV-4?????

Slide a small screwdriver under the tab in the middle of the blade and the arm, while pressing the tab in, pull blade away from the arm, this may need some extra wiggle. Remember you dont want it to fall off when driving..

Anonymous

  • 1 Answer
  • Posted on Mar 16, 2010

SOURCE: toyota rav 4 turbo diesel 2003 hard to start when

plenty power in battery turns over well just hard to fireup have checked heater plugs as you would think they were not working but they are ok even hard to start when warm after long drive say you stopped and went into shop for paper came out just the same hard to fireup

Anonymous

  • 202 Answers
  • Posted on Apr 26, 2010

SOURCE: 1999 toyota rav 4 engine oil cooler bolt torque setting

INSTALL OIL COOLER
-clean the oil cooler contact surface on the oil cooled mounting
-install a new O-ring to the oil cooler.
-temporarily install the oil cooler with the nut
-apply a light coat of engine oi on the threads and under the head of the relief vale
-install the plate washer and union bolt. torque 78Nm (800kgfcm, 58 ft lbs.)
-tighten the nut,torque 8.8Nm (90kgfcm, 78 inch lbs.)
-connect the 2 water bypass hoses to the oil cooler.

HOPE THIS CAN HELP.

Testimonial: "Great work thanks for the info."

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How do i check the transmission fluid and the coolent fluid

take the car for a drive for a few kilometres before checking the trans fluid and keep the car running in park while you check the fluid level and coolent you can check the resevior to see if it needs to be topped up
0helpful
1answer

2005 ford F350 6.0 diesel will not build power nor turbo power. Misses and losing coolent. will the egr cooler make it act this way

Sounds like a head gasket leak on the intake side or intake gasket. Your boost is leaking out and coolant is leaking into the cylinder. Get a bulletproof kit. It is well worth the money
0helpful
1answer

CAN ENGINE IN 98 RAV 4 BE REMOVED OUT THE TOP?

top- buy removing the 4 motor/ tranny mounts
bottom - buy droping it with the sub frame.
either way you need to remove the shift linkige. (and wiring)
0helpful
1answer

Toyota rav 4 2.2 diesel pinking

Several things. Improper grade of fuel.
Idle rpm too high
Excessive carbon build up on pistons and valves.
0helpful
1answer

My 2007 diesel auto Santa Fe Elite has an issue where it stalls or completely stops when it is warm (usually after driving for around an hour). It also loses power going up hills and jumps out of cruise...

hello I am having a issue with my santa fe diesel and currently suspecting that the oil that the service center is using is a generic oil used in both diesel and petrol engines. I am suspecting that the oil is too thin and causing compression in the cylinder issues and can be seen under load on low revs and very little responsiveness from the accelerator and at times the engines misses and has at one point stalled. You may also hear that the engine rattles on acceleration. I am going to experiment in putting in an oil particularly for diesels only and see if that makes a difference. I topped up 500ml before the last service on a 5w-40 diesiel synthetic oil and that seemed to make a big difference. I am guess 5w-30 will be better choice but did not have that sitting around at the time.
Be interested if anyone else experiments with an oil change and it works.
0helpful
1answer

Where is the Coolent bottle foud

hi

the coolent bottle wil be under the bonnet as soon as you open. it wil be on your left or right corners when you face the face.
it is a small bottle

if my answer were useful please vote for me
1helpful
1answer

1999 toyota rav 4 engine oil cooler bolt torque setting

INSTALL OIL COOLER
-clean the oil cooler contact surface on the oil cooled mounting
-install a new O-ring to the oil cooler.
-temporarily install the oil cooler with the nut
-apply a light coat of engine oi on the threads and under the head of the relief vale
-install the plate washer and union bolt. torque 78Nm (800kgfcm, 58 ft lbs.)
-tighten the nut,torque 8.8Nm (90kgfcm, 78 inch lbs.)
-connect the 2 water bypass hoses to the oil cooler.

HOPE THIS CAN HELP.
3helpful
2answers

Toyota rav 4 turbo diesel 2003 hard to start when warm.

plenty power in battery turns over well just hard to fireup have checked heater plugs as you would think they were not working but they are ok even hard to start when warm after long drive say you stopped and went into shop for paper came out just the same hard to fireup
0helpful
1answer

Coolent leak... 96 dodge caravan

if you get an overflow through the resevior it's often times because the thermostat with stick shut causeing excess pressure. seeing is the car is not overheating this means that the trhermostat is opening but when you get that overflow it's sticking i would replace the thermostat as soon as possible to resolve this issue
0helpful
1answer

Fuel presure dodge diesel ?

all i can tell you is that as long as you dont go below 4 psi you should not starve injection pump, this is a minimum psi though., 10-13 psi is average on my 2002 at service port.
Not finding what you are looking for?

98 views

Ask a Question

Usually answered in minutes!

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...