It only has one panel. Under the hood on the drivers side..
SOURCE: Set clock
Beside the analog clock display there is a small dot where you can insert a pen. When you push this in gently the clock starts moving very fast. Hold this button in until the time is correct. Make sure you stop before you go by the time you want because it only goes in one direction
SOURCE: Brake fluid reservoir on a 2005 Chrysler Pacifica
WHEN YOU OPEN YOUR HOOD LOOK DOWN THE DRIVER SIDE FENDER THEN LOOK LEFT ABOUT 10 INCHS AND YOU SOULD FIND IT IT WILL BE WHITE IN THE ENGINE COMPARTMANT AREA
SOURCE: 2006 Chrysler Pacifica Auotmatic Liftgate
Yes new gas shocks on the lift gate will fix your problem. I had the same problem on my 2005 Pacifica and when it hit my head- I came up with the solution.
Good Luck,
Ray
SOURCE: program instruction garage door opener in 2005 chrysler pacifica
if your garage motor have rolling codes you need to put your car inside garage near the motor leave ignition on go to the motor locate learn button press it then quickly go to the car and press and hold one of the buttons for approximately 30 sec or until it start blinking rapidly, if you have a regular motor take one hand held opener go inside car ignition on same time press open button on handheld remote and on the car button 30 sec and it should be programmed.
SOURCE: 2005 Chrysler Pacifica Washer Pump
The washer pump is located in the bottom of your windsheild washer reservoir. You will have to remove the wheel well cover to access it and check the plug in harness to make sure it is connected. Place a voltmeter on the to leads of the harness and have an assistant push the windshield washer button with ignition on. There you will see if your getting volts to the end of the harness. If you do, then the pump is bad. Replace it while you have access to it.
2,314 views
Usually answered in minutes!
×