How do I replace the header panel with headlights on my 1992 Oldsmobile cutlass ciera

SOURCE: The windows in the 95 oldsmobile cutlass ciera won't work at all

maybe the wire is severed where the door (drver dr) pivots. thats what was wrong with mine. there is a rubber boot with crinkles in it that hold all the wires together. you can also try replacing the switch board that controls the wndws on the drvr dr. hope that helps.

Colin Stickland

• 22516 Answers
• Posted on Jan 24, 2009

SOURCE: how to change a starter in a 1992 oldsmobile cutlass ciera

disconnect battery,three bolts hold it to bell housing and two wires ,one is the feed the other activates the solonoid Easy job to do but dirty dirt grease and muck

SOURCE: changed spark plugs and wires now car wont start

I know this might be obvious but the obvious is often the problem. Did you replace the coil wire that goes from your coil to the distributor cap? Also, double check to be sure that your wires are connected in the correct order. A little more clarification might help. Does it turn over? Does it just click? When you turn the ignition key then let off does the car clunk or make a wheezing sound?

SOURCE: Changing spark plugs on a 1995 Oldsmobile Cutlass Ciera

ALL YOU NEED IS 3/8 RATCHET WITH A 5/8 SPARK PLUG SOCKET.YOU NEED EXTENSIONS AND UNIVERSAL JOINTS TO GET TO HARD TO REACH PLACES.YOU NEED A SPARK PLUG GAUGE.YOUR SPARK PLUG GAP SETTING WILL BE. 0.060 THAT WILL BE FOR THE 2.2 AND 3.1 ENGINES.

Testimonial: "Thank you very much for your advice and time!"

SOURCE: 1989 oldsmobile ciera no spark unit cranks fine good fuel presure

most common cause of no spark is the ignition module located under the coil