Where is the starter at on 97 Hyundai at - Hyundai Cars & Trucks

Question edited for clarity and good order.
Question moved to moved to model category.

They tend to hide them under the engine and you access from behind the wheel.

2007 Hyundai Santa Fe Starter

AutoZone.com https://www.autozone.com > hyundai > santa-fe > 2007
PRICE: 215.99 · Mounting Shims Included: No · Tooth Quantity: 9 · Voltage: 12.0 · Family: PMGR (Permanent Magnet Gear Reduction) · Starter Rotation: Clockwise ...

Hyundai Santa Fe Starter Replacement Cost Estimate

RepairPal.com https://repairpal.com > Estimator > Hyundai > Santa Fe
The average cost for a Hyundai Santa Fe Starter Replacement is between $408 and $515. ... Labor costs are estimated between $77 and $97 while parts are priced ...

Get the Best Priced Hyundai Santa Fe Starter

Parts Geek https://www.partsgeek.com > ... > Santa Fe Parts
Replacing a 2009 vehicle starter costs $412 to $514. Repairs at the 2006 Hyundai Santa Fe starter location run from $209 to $276, so model year does have ... ..

Here's a link to what your crankshaft sensor looks like. Duralast Crankshaft Position Sensor SU4127 ReadReviews onDuralast SU4127 The Crankshaft Position Sensoris located: Under hood, center, upper engine area, mounted in front passenger side of engine block.Here's another link on replacing your sensor.
Repair Guides Electronic Engine Controls Crankshaft Position ckp Sensor...

Check your starter relay fuse..... New battery....

It goes to the starter motor.

Bosch have a replacement starter for the elantra. I do not have the part number but your auto shop is suppose to have it.

SOME TIME THERE ONLY ONE BOLT TO REMOVE BECOS IT SLIDES ON PINS FROM THE STARTER

the neg wire goes on the bolt that holds the starter, there should be a positive cable wire that goes to the big bolt on the back of starter seleniod and then a small wire that goes to the small connection on the seleniod,then then neg goes to the block or one of the bolts that holds the starter in,

check ignition coil current supply and or distributor contact point or condenser/ ur cars current supply fluctuate when engine is hot....

go ahead and change the filter. There is no need to bleed it after changing the filter. Just start up the vehicle and let it run for a minute or two.

'94 through '97 should share the same starter.