SOURCE: hyundai accent, location of fuel cut off
hi from uk location of fuel safety shut off valve/switch on uk r/h drive accents is on the engine bay bulkhead in front of drivers side it is a square box with red rubber top press button may be on opposite side on l/h drives ? if activated? just press button till click ? to reset these normally only cut off on impact ? to stop elec fuel pump continuing delivering if involved in an R.T.A fire prevention
SOURCE: trunk light and dash light always on
I would have to agree it's an electrical problem. It might simply be a defective trunk lid latch switch. Here's the wiring diagram:
SOURCE: need to replace dash board backlights - 2004 hyundai elantra
trying to do the same on my 01. ready to change the bulb but can't find it anywhere.
anyhow, here's how you do it:
remove the dash by taking out 2 screws behind the ashtray and 2 above the instrument cluster
begin prying off the dash from the ashtray up, when you reach the heater vents stop. next take a flat head screwdriver and pry off the dash from the left side with the door open. work left to right till you reach the heater vents and it'll come right off. you don't necessarily have to unplug any of the electric connectors if you don't want to, but you;ll have to reach around the dash while working. all you need to do now is remove the heater control unit via the 4 screws around it, then unplug the electric harnesses from the back of it. make sure you remember which goes where. the bulbs are the 3 white (or is it 2 white and 1 grey) circles on the back of the control unit. just turn them with a flathead screwdriver and turn it over and give it a little bump to get 'em to fall out (or grab 'em with a needle nose pliers if necessary). anyhow, that's how it's done, question is, where do ya find the bulbs?
SOURCE: How do I disassemble the [center]dash to replace
remove all the screws
there are 2 in center console at side 2 in ash tray and 2 others usually look arround pull gentley and locate all screws
SOURCE: 00 hyundai accent, wont start light on dash with
Could be as simple as a blown fuse for the ETACS module, but it sounds more like a problem with the anti theft immobilizer system. Does your car have remote keyless entry? And is the key you are using a factory key or one someone made? (factory key will be encased in bulky black plastic with hyundai logo) The transponder in the key might have worn out and is not talking to the car anymore. Some hyundais use the radio antenna to receive the signal, is there an antenna on the car? Is it hooked up? If it is a problem with the key and immobilizer system, It will unfortunately need towed to a dealer and reprogrammed.
58 views
Usually answered in minutes!
×