1995 Honda Civic Logo

Related Topics:

Rachel Kathleen Baum Posted on Nov 26, 2016
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

95Honda civic ex automatic changed the ignition wiring harness it starts but only stays on if I hold key back a little and no dash lights until I turn back to position 11 HELP PLEASE

1 Answer

Bill Boyd

Level 3:

An expert who has achieved level 3 by getting 1000 points

Top Expert:

An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

  • Honda Master 53,816 Answers
  • Posted on Jan 09, 2017
Bill Boyd
Honda Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Top Expert:

An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

Joined: Jan 04, 2013
Answers
53816
Questions
7
Helped
11949998
Points
172802

Run circuit wire is in the wrong place on the start switch

5 Related Answers

Anonymous

  • 1990 Answers
  • Posted on Jan 04, 2009

SOURCE: ignition won't stay in running position.

You are gonna need a New Ignition. Will solve this Problem.

Ad

Anonymous

  • 11896 Answers
  • Posted on Jan 17, 2009

SOURCE: 1991 honda accord ex headlight problems

Hello, firstly I was wondering if the lights shut off when you pull the switch off the harness?
If YES, then THAT switch or wiring could be bad
if NO, then it's most likely the body control module

fordexpert

  • 5692 Answers
  • Posted on Jun 08, 2009

SOURCE: 2000 Grand Voyager blowing the ignition fuse

Was the old fuel pump bad? It might be worth the cost to replace the ignition switch. The wires to the fuel pump would be a second guess if the old pump was bad and burnt the wires before the fuse went. When you eliminated the fuel pump you also eliminated the wires to the pump and it started. Then you replaced the pump, but not the wires. The ignition switch is the other end of the circuit.

Anonymous

  • 179 Answers
  • Posted on Jul 06, 2009

SOURCE: where is the starter relay on a 94 Honda Accord

Yes, it sounds like your solenoid is bad and staying engaged against the flywheel, you could do an amperage draw and a voltage drop test to find out for sure, but you will need an DVOM and a amp clamp. Or you could take it into an auto parts store and they will test it for free. Hope this helps.

Anonymous

  • 64 Answers
  • Posted on Jul 10, 2009

SOURCE: 2001 honda civic ex

if its a standard check the clutch pedal switch if its an auto check the neutral safety switch and check the fuse in the fusebox that says CRANK

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2000 honda cvic will not start but if you push on the it will try to start but will not stay running

Do you notice anything unusual with the dash lights when you turn the key on. All the warning lights should illuminate. If they do not but then come on as you start to rotate the key into the start position than you probably have a bad ignition switch.

If you turn the key to the start position and hold it there (only do this for a few seconds) will the car stay running until you let go of the key? Another clue that the ignition switch may be bad.

if you turn the key to the start position and the vehicle starts slowly let the key rotate back to the run position until the starter disengages. If the vehicle continues to run let go of the key. If the vehicle stalls than the ignition switch is definitely bad.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

2helpful
2answers

My maintenance required light came on and stays on. since maintenance required is such a broad subject, i was wondering how i can determine what may be causing this problem is it possible that it's the...

normally if its going to be an O2 sensor,, the check engine light would come on, not the maintenance light, I don't know if your car has 2 different ones, My 2000 civic does though,, normally a maint light comes on if its time for an oil change , etc... rest the light,, heres how you do that you use the button that resets your trip odometer to reset the maintenance light.

with the key in the ignition but not turned on, hold the trip reset button in with one hand. then, while holding the button in, turn the ignition key to the ON position so that the lights on the dash come on.

continue to hold the reset button in and watch the maintenance light. it will take about 15 seconds for the light to go out

when the light goes out, turn the ignition key OFF and then release the trip reset button.

your light will be reset and come on in about another 5000 miles to remind you of the next service
0helpful
1answer

I have a 1997 jeep grand cherokee laredo 4.0 that will not start, it wont even crank at all!! This jeep is becoming a real pain in the ****. It has been driven every day and has driven normal like always...

Okay, headlights are nice and bright and battery is still fully charged, if theres no dash lights and doesnt start and you have replaced the ignition swith, this switch is the elctrical switch not the key part correct, then the onlt other thing i can think off that ive run into on these wranglers is a wiring harness that supplies power to ignition system, this wiring comes throught the firewall into cab at the center area of the dash there it has a connector that connects it together, the wires heat up and melt in the connector this is a main power wire in this harness that melts, this harness contains about 4 to 7 wires,hold the key in the crank postion and start moving wire harnesses around under the dash, you will need to look closely ther are not that many harness under that dash, it will be in the center and toward driverside. hope this helps.
1helpful
3answers

Car started an hour ago now wont turn over security light in dash came on and stays on

if the security light is on then it is the VATS system. the ignition switch is fine still.
0helpful
1answer

My 1991 Honda Civic Hatchback (automatic) was broken into last night. They got into the passenger door but nothing is taken or visible wrong, however my check engine light comes on and stays on when I try...

B******s! It could be that when they broke they tried to get your car going and they triggered the immobiliser and this may need to be reset. On the other hand with many automatics you can only remove the ignition key once the transmission is in 'park' and the steering lock has engaged. I wonder if they may damaged the parking interlock mechanism between the ignition point and the gear selector by messing with the locked steering wheel. Check that the steering lock unlocks OK and that the car is unable to start in any other gear position, try 'neutral'
0helpful
1answer

I just rebuilt my 96 CX civic's entire interior. The only wiring changes that were made were to add a 98 civic ex's floor mounted wiring and door wiring so I could install power windows and locks. I also...

is there a emobileliser in your civic? ive a 98 hatchback civic with an emobileliser in it and if i set it off same thing loud click and wont let me take out the key,,then i reset it from the side of the steering wheel ,with this special thing i have with my key,,,,sounds weird whats happing to you,,let me know more if u can
0helpful
1answer

1994 Honda Civic not starting

you need to check all fuses one by one for loose contact.leave the igtion key to on position and try to tap the fuse box, shake wires from battery going to inside the car.A testlight is effective in diagnosting this trouble.Probing the wires on the ignition switch while turning on the key.Need somebody to observe the cluster while performing the troubleshooting.
1helpful
1answer

Have power and accessories until key is turned to start

U will need to replace the ignition switch, this is not the key cylinder but the actual electrical switch the key cylinder operated. see photo. I noted that on your model Honda the switch comes with a new key cylinder, you can just use the switch and use your old cylinder over or install the new parts together.


0159adc.jpg
0helpful
1answer

1991 honda accord ex headlight problems

Hello, firstly I was wondering if the lights shut off when you pull the switch off the harness?
If YES, then THAT switch or wiring could be bad
if NO, then it's most likely the body control module
Not finding what you are looking for?

72 views

Ask a Question

Usually answered in minutes!

Top Honda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...