Time to have the battery , alternator tested by an accredited auto electrical shop
batteries test good but fail if a load tester is used and having to jump start it indicates that the battery is not good
If there is not enough power available to run the ECM then it will die when the battery voltage drops below required voltage
the fact that ir runs for a while and dies indicates that the alternator is not producing sufficient power to run the battery and the ECM again indicating a bad battery
SOURCE: why does my starter bolt keep coming loose
Have you tried “lochtite strong hold” thread sealer and allowed 8 hours to setup?
SOURCE: 2000 eclipse starts but wont idel
its the idle air contol motor. its located on the bottom of the throttle body.
SOURCE: car cutting off ,battery or the alternator
i work for advanced auto
the altiniator can bee goood but the voltige regulator is bad
SOURCE: Stalls when at idle after changing battery
When you changed the battery the computer must re-learn the setting again. If it continues have a OBD II reader plugged in and check for codes.
107 views
Usually answered in minutes!
I would replace the fuel filter. As you run the car the filter screen becomes cloged. When it sits, all the junk settles back down clearing the screen only to be stired up again when it's running. Good Luck
thank you..we'll look in to that too but when it stalls we have to jump it. no juice. battery has been tested and we were told its good.
×