Preliminary Procedure
Remove the instrument panel left outer trim panel. Refer to Instrument Panel Outer Trim Cover Replacement .
Remove the left closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
Remove the data link connector.
1
Screws, Knee Bolster (Qty: 3)
Tighten
2 N·m (18 lb in)
2
Knee Bolster Assembly
3
Retaining Clip, Knee Bolster (Qty: 3)
Callout
Component Name
Notice: Refer to Fastener Notice in the Preface section.
Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .
1
Screw, Instrument Panel Closeout/Insulator (Qty: 2)
Tighten
2 N·m (18 lb in)
2
Nut, Instrument Panel Closeout/Insulator (Qty: 1)
Tighten
2 N·m (18 lb in)
3
Panel Assembly, Instrument Panel Closeout/Insulator
Removal Procedure
Remove the fuse labeled HVAC CTRL (BATT).
Remove the left closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
Remove the knee bolster. Refer to Knee Bolster Replacement .
Remove the mode actuator retaining screws.
Remove the mode actuator.
Disconnect the mode actuator electrical connector.
946 views
Usually answered in minutes!
×