Also where does it connect at the other end.
SOURCE: 1993 Ford Probe needs motor mounts
is the model with the V6 mazda motor, if so it can be a bit difficult if you have little mechanical experience, but it is doable without removing the motor or transmission. we would allow 3 hours to complete the whole job.
SOURCE: replacing front driver side (F150) brake line (rubber hose)
Brake fluid is highly corrosive. If you can't get the line loose on the frame side then I would suggest replacing the hard line as well coming from the master cylinder. Or if you have a flaring tool you could cut the hard line just behind the rubber and put a new fitting on it. Pretty easy if you have the tool. Essentially you will wind up kinking or breaking the hard line anyway if the fitting won't come loose easy.
SOURCE: Want to replace fron in 93 ford probe
1993 is a split year, if you have charging ports are a little bigger than the size of a tire valve stem then u have R12, if they are big then you have R134, most all Ford in 93 use R12. In the picture are adapters for a retrofit to R134, these screw on an R12 port, note the large cap R134 cap on the end of the adapter.
SOURCE: 94' Ford Probe Automatic Transmission fluid check question
The car needs to be running with the transmission warm, (drive around for at least 10 minutes) Place the car in neutral. Pull the stick wipe it off and place it back in the transmission. Reads just like an oil stick, want fluid in the safe range (checked pattern) area.
63 views
Usually answered in minutes!
×