How do you remove center console on a 2000 Chevy Tracker to get at the light

SOURCE: air bag light

well yes and no, yes because when you get into an accident your air bags will not work, but while the light is on or flashing the cars computer has cut power to the air bags because of some kind of error have you hit any thing latley with the car? try disconnecting the battery for a minute and reconnect it and see if it still does it

SOURCE: 2000 chevy tracker egr gone bad what are opitons to fix

usually egr sensor goes bad sometimes tube best to use new parts old ones may not work andwork short time

SOURCE: I need a serpentine belt/routing diagram 2000 chevy tracker.

For the 2000 Chevrolet Tracker:

Most modern vehicles have the Belt Routing Diagrams on the undeside of the Hood. But the sometimes disappear.

I do not know if you have the 1.6L In-Line 4-Cylinder, or the 2.0L DOHC In-Line 4-Cylinder. Nor what Engine Options you have (AC/No AC, etc.).

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

http://www.2carpros.com/car_repair_information/year/2000/make/chevrolet/model/tracker/2000_chevrolet_tracker_drive_belt_routing_diagram.htm

SOURCE: 2000 chevy tracker orange dashboard power light

it's just a switch that you hit. sitting in the driver's seat, look down to your right, on the left of the shifter and click that switch

ZJ Limited

• 17989 Answers
• Posted on Jul 11, 2011

SOURCE: Do you have to remove

Check this Transmission Removal & Installation

1. Drain the transfer case oil, if equipped.
   
2. Remove or disconnect the following:
   Negative battery cable Center console and transfer case shift lever, if equipped Transmission dipstick tube Transmission wiring harness connectors Starter motor Front driveshaft, if equipped Rear driveshaft Gear select cable and bracket Throttle Valve (TV) cable, if equipped Exhaust front pipe Transmission oil cooler lines Transmission brace Flywheel access cover Torque converter Speedometer cable, if equipped Vehicle Speed (VSS) sensor connector, if equipped Transmission flange bolts and nuts Transmission braces, if equipped
3. Support the transmission with a jack and remove the transmission mount and crossmember.
   
4. Place a wooden block at the rear of the cylinder head as shown to support the engine when the transmission is removed.
   
5. Lower the transmission away from the vehicle.