All 4 bangers, not boxer engines (cars)
are 1,3,4,2.
this is 4aFE or 7Afe, Corolla engine, in Geo snake skins.
why not post whats up.
did you remove the distributor.?
or just pulled off the wires willly nillly
knowing what you did,
is the path to short easy answer.
or just spin it off time, with dist, clamp loose.
there are lots of ways to mess up a distributor. seen them all. I have.
×
SOURCE: 1996 geo prizm
you'll have to pull off the interior panel. window in the up position. on the lock cylinder there is a clip that you have to pull off and an arm that actuates the lock. pop the lock out. reverse to install.
SOURCE: THE FIRING ORDER FOR A 1992 GEO METRO
The firing order is 1-3-2, distrubtor rotates counter clockwise. looking at engine from front of vehicle cyl. # 1 will be on your left cyl.# 2 center and cyl.# 3on your right.
SOURCE: blower motor location 1990 geo prizm
In my 1992 it is underneath the dash on the passenger's side, but you have to take the whole front panel including the glove box off to access it. When that is done there is a rectangular housing and a more circular housing. On the bottom of the circular housing there are three screws that hold the blower motor up. Remove the screws and it will drop right out.
SOURCE: how to replace a 1996 Geo Prizm front wheel
Place the car on jacks. Remove the seal using a screw driver and a rubber mallet. Remove the carter pen, then the bolt. Remove the bearing. Clean out the eitire wheel area with a good cleaner. REpack the bearing unless it comes pre packed with wheel bearing grease.
425 views
Usually answered in minutes!
×