Lift car on jack stands, disconnect the car battery and while under car you will find two bolts that hold it heat shield on front and back of starter. After removing the heat shield, this will give you access to the bolt against the engine on top. Two other bolts easy to get to. Disconnect wires to starter and then remove bolts. Install in opposite procedure
SOURCE: 1999 olds cutlass glove box removal
you need to remove all the screws on the bottom of the glove box on the outside, then on the inside remove all the screws too. and then pull it out. sometimes some glove boxes have stoppers on the edge of the door inside and you have to pry on them to pull the stoppers in front of the side of the glove box so you can remove it entirely from the dash.
SOURCE: how to change a starter in a 1992 oldsmobile cutlass ciera
disconnect battery,three bolts hold it to bell housing and two wires ,one is the feed the other activates the solonoid Easy job to do but dirty dirt grease and muck
SOURCE: 1999 Oldsmobile Cutlass Cigarette Lighter Fuse
Under the hood directly in front of the driver is a covered fuse block. Remove the cover and the fuse is #34.
SOURCE: car will not start, starter will not engage
REMOVAL & INSTALLATION
Fig. 1: Unfasten the starter motor electrical connections. You may want to tag them first to avoid confusion
Fig. 3: The starter is attached to the engine with 2 mounting bolts (see arrows)
More coming
470 views
Usually answered in minutes!
What engine does the vehicle have? If it is the 3.4L you will need to lower the front of the engine cradle slightly to remove the starter.
Its a 3100 sfi v6
×